Loading ...
Loading ...
Loading ...
12
If the “low” ame needs to be adjusted:
1. Light 1 burner and turn to lowest setting.
2. Remove the control knob.
Hold the knob stem with a pair of pliers. Use a small
atblade screwdriver to turn the screw located in the center
of the control knob stem until the ame is the proper size.
3. Replace the control knob.
4. Test the ame by turning the control from “LO” to “HI,”
checking the ame at each setting.
5. Repeat the previous steps for each burner.
Check Operation of Oven Bake Burner
1. Remove the oven rack.
2. To remove the oven bottom: Remove 2 screws at the rear of
the oven bottom. Lift the rear of the oven bottom up and
back until the front of the panel is away from the front frame.
Remove it from oven and place on a covered surface.
3. You can check the burner ame by removing the ame
spreader or by using a mirror.
Remove ame spreader:
Remove 2 screws from the front tabs of the ame spreader. Lift
front of the ame spreader and pull forward to remove tabs from
rear of oven.
Using a mirror:
Insert a mirror to one side of the burner. Look into the mirror to
check ame.
4. Push the BAKE pad.
5. Press the START pad.
The oven bake burner should light within 8 seconds. Under
certain conditions, it may take the burner up to 50 to 60 seconds
to light.
Electronic igniters are used to light the bake and broil burners.
Refer to the Use and Care Guide or User Instructions for proper
operation of the oven controls.
Adjust Oven Bake Burner Flame (if needed)
1. On models with a warming drawer, remove access cover
plate (1 screw) located at the back of the warming drawer
compartment.
2. Check the oven bake burner for proper ame.
This ame should have a 1/2" (1.3 cm) long inner cone of
bluish-green, with an outer mantle of dark blue, and should
be clean and soft in character. No yellow tips, blowing or
lifting of ame should occur.
3. If the oven bake ame needs to be adjusted, locate the air
shutter near the center rear of the range. Loosen the locking
screw and rotate the air shutter until the proper ame
appears. Tighten locking screw.
4. Push CANCEL/OFF when nished.
5. Reinstall ame spreader and oven bake burner cover.
Check Operation of Oven Broil Burner
1. Close the oven door.
2. Press the BROIL pad.
3. Press the START pad.
The oven burner should light within 8 seconds. Under certain
conditions, it may take the burner up to 50 to 60 seconds to
light. Refer to the Use and Care Guide or User Instructions for
proper operation of the oven controls.
Adjust Oven Broil Burner Flame (if needed)
Look through oven window to check broil burner for proper
ame. This ame should have a 1/2" (1.3 cm) long inner cone of
bluish-green, with an outer mantle of dark blue, and should be
clean and soft in character. No yellow tips, blowing or lifting of
ame should be present.
A
B
C
A. Control knob stem
B. Screwdriver
C. Pliers
A
B
A. Screws
B. Oven bottom
A
B
C
D
A. Mirror
B. Flame spreader
C. Flame reflection
D. 2 screws
A
B
A. Locking screw
B. Air shutter
Loading ...
Loading ...
Loading ...