Loading ...
Loading ...
Loading ...
Features of your vehicle
4-52
Operating HomeLink
®
To operate, simply press and release
the programmed HomeLink
®
button.
Activation will now occur for the
trained device (i.e. garage door
opener, gate operator, security sys-
tem, entry door lock, home/office
lighting, etc.). For convenience, the
hand-held transmitter of the device
may also be used at any time.
Reprogramming a single
HomeLink
®
button
To program a new device to a previ-
ously trained HomeLink
®
button, fol-
low these steps:
1.Press and hold the desired
HomeLink
®
button. Do NOT release
until step 4 has been completed.
2.When the indicator light begins to
flash slowly (after 20 seconds),
position the handheld transmitter 1
to 3 inches away from the
HomeLink
®
surface.
3.Press and hold the handheld trans-
mitter button. The HomeLink
®
indi-
cator light will flash, first slowly and
then rapidly.
4.When the indicator light begins to
flash rapidly, release both buttons.
5.Press and hold the just-trained
HomeLink
®
button and observe the
red Status Indicator LED. If the
indicator light stays on constantly,
programming is complete and your
new device should activate.
Erasing HomeLink
®
buttons
Individual buttons cannot be erased.
However, to erase all three pro-
grammed buttons:
1.Press and hold the two outer
HomeLink
®
buttons until the indi-
cator light begins to flash-after 20
seconds.
2.Release both buttons. Do not hold
for longer than 30 seconds.
The Integrated HomeLink
®
Wireless
Control System is now in the training
(learn) mode and can be pro-
grammed at any time following the
appropriate steps in the Programming
sections above.
Loading ...
Loading ...
Loading ...