Loading ...
Loading ...
Loading ...
ENGLISH
11
HOW TO OPERATE
CHOOSING A LOCATION
You will use the oven frequently so plan its location for ease of use.
Allow at least 2 inches on the sides, top and at the rear of the oven for
air circulation. Do not place or install the oven in any area where heat
and steam are generated; for example, next to or above a conventional
gas or electric range or above a conventional wall oven. Heat and steam
may damage the electronics or the mechanical parts of the oven.
AFTER PLUGGING IN
As soon as the microwave is plugged into the outlet, the
LED Display will flash three times. Then the LED Display
will flash ":" which prompts you to enter the time.
SETTING THE CLOCK
While the LED Display reads "•
:", press the DELAY/CLOCK button once.
The LED Display will then read 0:00 and the 0: on the far left will flash.
Turn the PROGRAM DIAL clockwise to change the hour to single digit numbers. •
Turning it counterclockwise will change the hour to double digit numbers.
Continue to rotate the PROGRAM DIAL in the desired •
direction until you have the correct hour.
Once you have set the hour, press the DELAY/CLOCK •
button again to confirm your selection.
Now the :00 on the right will flash. Follow the same directions •
above for setting hours to set the correct minutes.
Once you have set the correct time, press the DELAY/•
CLOCK button again to confirm your selection.
CONTROL PANEL
PROGRAM DIAL
The PROGRAM DIAL is a multi-functioning controller. It
can be used to set the time on the clock, adjust cooking
time and to select a pre-defined cooking program.
Quick Start:• Pressing the PROGRAM DIAL once will immediately
start a cooking cycle for one minute at maximum power.
Adjusting Time: • You can adjust the cooking time by either pressing
the PROGRAM DIAL additional times to add 30 second increments,
or turning the PROGRAM DIAL clockwise to increase time by
seconds and counter-clockwise to decrease time by seconds.
Selecting a Cooking Program: • Turning the PROGRAM DIAL counter-
clockwise prior to starting a cooking cycle allows you to select a cooking
program. The LED Display will light up to show which program is selected.
Program selections are: BEV (Beverage, cook), POP (Popcorn, cook), FROZ
(Frozen Entrée, cook), VEG (Vegetable, cook), SPUD (Potato, cook), RICE
(Rice, cook), BRED (Bread, reheat), PIZZ (Pizza, reheat), DISH (Dinner Plate,
reheat), FISH (Fish, defrost), CHIC (Chicken, defrost), BEEF (Beef, defrost).
Once you have selected your desired program, press the PROGRAM DIAL.
Loading ...
Loading ...
Loading ...