Loading ...
Loading ...
Loading ...
12
or
Runs the dishwasher at
a later time or during off-
peak electrical hours.
Select a wash cycle and
options. Press the Delay
button. Press START/
RESUME. Close the
door firmly.
NOTE: Anytime the door is
opened (such as, to add a
dish), the Start/Resume
button must be pressed
again to resume the
delay countdown.
Available with
any cycle
Delays the start
of a cycle to the
specified time
.
240 480 0
or
Avoids unintended use of the dishwasher between cycles or cycle and option changes during a cycle.
To turn on Lock, press and hold CONTROL LOCK or 4 HOUR DELAY (depending on model) for 3 seconds. The Control
Lock light will stay on for a short time, indicating that it is activated and all buttons are disabled. If you press any button
while your dishwasher is locked, the light flashes 3 times. The dishwasher door can still be opened/closed while the
controls are locked.
NOTE: You may need to disable Sleep mode by pressing either START/RESUME or CANCEL, or by opening and
closing the door before you are able to turn Control Lock off.
To turn off Control Lock, press and hold CONTROL LOCK or 4 HOUR DELAY (depending on model) for 3 seconds. The
light turns off.
NOTE: If your model requires you to press and hold 4 HOUR DELAY to lock the controls, the Control Lock LED will be
on or off to indicate if Control Lock is active or not.
OPTION SELECTIONS
OPTIONS CAN BE
SELECTED WITH
WHAT IT DOES ADDED TIME TO CYCLE ADDED
WATER
GALLONS
(LITERS)
TYPICAL MAX
CONTROLS AND CYCLE STATUS
CONTROL PURPOSE COMMENTS
To start or resume
a wash cycle
If the door is opened during a cycle or the power is interrupted, the Start/Resume indicator
flashes. The cycle will not resume until the door is closed and START/RESUME is pressed.
NOTE: If the Start/Resume button is located on top of door, push door firmly closed within
3 seconds of pressing START/RESUME. If the door is not closed within 3 seconds, the
Start/Resume button LED will flash, an audible tone will be heard, and the cycle will
not start.
To reset any cycle
or options during
selection.
To cancel a wash
cycle after it's
started.
Press and hold CANCEL/DRAIN to reset any control selections made.
See “Canceling a Cycle” and “Changing a Cycle After Dishwasher Is Started” sections.
To turn the audible
tones on or off.
Press and hold the Hi-Temp Wash button for 3 seconds to turn the audible tones on or off.
Only audible tones for confirming button presses can be turned on/off. Important audible
tones, such as indicating a cycle has been interrupted, cannot be deactivated.
Loading ...
Loading ...
Loading ...