Loading ...
Loading ...
Loading ...
5
Cleaning (prior to use)
• Wash any removable parts, the freezer
interior, and exterior with mild detergent
and warm water. Wipe dry. Do not use
harsh cleaners on these surfaces.
• Do not use razor blades or other sharp
instruments, which can scratch the
appliance surface when removing adhesive
labels. Any glue left from the tape can be
removed with a mixture of warm water and
mild detergent, or touch the residue with
the sticky side of tape already removed. Do
not remove the serial plate.
Door Removal (non-electronic
models)
If door must be removed:
1. Gently lay freezer on its back, on a rug or
blanket.
2. Remove two base screws and base panel.
3. Remove bottom hinge screws.
4. Remove plastic top hinge cover.
5. Remove screws from top hinge.
6. Remove top hinge from cabinet.
7. Remove door and bottom hinge from
cabinet.
8. To replace door, reverse the above order
and securely tighten all screws to prevent
hinge slippage.
Plastic
Leveling Feet
Crating
Screw
Discard The (4) Crating Screws
And (2) Wood Bases
Tu r n
Left To
Raise
Tu r n
Right To
Lower
Unpacking and Leveling -- Upright Models
Shelf Front
Door Removal (electronic
models)
If door must be removed:
Door hinge is fastened with tamper-proof
screws.Pleasehaveaqualiedtechnician
remove the door.
INSTALLATION
CAUTION
To allow door to close and seal properly, DO
NOT let food packages extend past the front
of shelves.
To Level Upright Models:
After discarding crating screws and wood base,
use a carpenter’s level to level the freezer from
front-to-back. Adjust the plastic leveling feet in
front, ½ bubble higher, so that the door closes
easily when left halfway open.
To Level Chest Models:
If needed, add metal or wood shims between
footpadsandoor.
Loading ...
Loading ...
Loading ...