Loading ...
Loading ...
Loading ...
4
BEFORE FIRST USE
Fill to max, boil, discard the water, then rinse. Do this twice to remove any manufacturing dust,
etc.
FILLING
1. Remove the lid.
2. Fill with at least 1 cup of water, but not above max.
3. If you want only 1, 2, or 3 cups of water, ll to the 1, 2, or 3 marks inside the kettle.
4. Ret the lid.
USING YOUR KETTLE
1. Put the stand on a stable, level surface. Wind excess cable beneath the stand.
2. Plug the stand into the wall socket.
3. Put the kettle on the stand.
4. Move the switch to I. The light will come on and the kettle will start to heat.
5. When it boils, the kettle will switch o.
6. To switch o manually, move the switch to O, or simply lift the kettle o the stand.
GENERAL
Note: When you lift your kettle, you may see moisture on the stand. This is normal and is caused
by the steam used to switch your kettle o automatically.
BOIL DRY PROTECTION
If your kettle boils dry, a safety cut-out device will automatically switch it o. If this happens,
unplug your kettle and allow it to cool down until the cut-out resets itself. Allowing your kettle
to boil dry will shorten the life of the element.
CARE AND MAINTENANCE
1. Unplug the stand, and let the kettle cool before cleaning.
2. Wipe all surfaces with a clean damp cloth.
3. Keep the connectors dry.
4. Open the lid.
5. Squeeze the top of the lter to release it from inside the rim of the kettle, then lift it out of
the kettle.
6. Rinse the lter under a running tap while brushing with a soft brush.
7. Fit the bottom of the lter into the seam between the oor of the kettle and the wall.
8. Locate the lter in the rear of the spout.
9. Squeeze the top of the lter, then t it under the rim of the kettle.
10. Close the lid.
Loading ...
Loading ...
Loading ...