Loading ...
Loading ...
Loading ...
11
WARNING
• Clean as instructed only the oven parts listed in this manual.
• To avoid dangerous fumes and surface/accessory damage, use only
the cleaning solutions specified in this manual.
• Before cleaning, ensure the oven is off and all parts are cool.
• Do not use abrasive/corrosive cleaners or applicators (e.g., steel
wool, scouring pads) anywhere on the oven except as instructed.
Use only a sponge, soft cloth, fibrous or plastic brush, or nylon
cleaning pad on the oven surfaces.
• Do not steam-clean the oven exterior. Steam could penetrate the
electrical parts and short the circuit.
• Do not use sharp objects (e.g., knife, metal spatula) to remove
heavy spills.
About Self-Clean Mode
• For best results, the oven chambers should be cleaned regularly.
The self-cleaning feature heats the oven to very high tempera-
tures to burn off surface deposits and takes about 2 ½ hours.
•
also emits popping sounds during self-cleaning due to metal
expanding/contracting as the oven heats and cools.
• Remove the meat-temp probe before entering self-clean mode.
• If soild remains after self-cleaning, you may run another cycle.
• Self-clean the oven regularly to prevent residue buildup.
WARNING
• For less smoke and better efficiency, wipe up grease and other
residue with a damp cloth before self-cleaning. (See the cleaning
instructions on this page.)
• Exterior oven surfaces will be very HOT during self-cleaning.
• To avoid product damage/ruin, remove the racks and all foreign
objects from the oven during self-cleaning.
Using the Self-Clean Feature
IMPORTANT
• Double ovens: Due to the amount of power consumed, only one
oven chamber can be self-cleaned at a time. You cannot cook in the
other oven when one is in self-clean mode.
• For their protection, the oven lights are disabled during self-cleaning.
• Remove the meat-temp probe before self-cleaning. (The probe
icon blinks if you try to start self-cleaning with the probe attached).
1. Remove the racks and all other loose objects from the oven
chamber. (See Pg. 12
2. Wipe the interior door surfaces outside the door gasket with
a vinegar-water solution, then wipe them dry. Clean heavily
soiled areas with a plastic scouring pad.
3. Dab the door gasket gently with a soft cloth moistened with a
mild-soap and water solution.
CAUTION
• To avoid compromising the tight seal needed for best function, do not
scrub the door gasket.
• Forcing open the locked oven door may damage the door and latch.
4. Turn on kitchen fans or vents to help remove odors during
self-cleaning.
5. Shut the oven door, and tap SELF CLEAN.
6. Tap START/CONTINUE.
The oven door locks automatically to prevent personal injury
from the high temperature generated during the cycle. If the
door is ajar, an error message appears on the display. To clear
the error, touch CANCEL/SECURE, wait 1 minute, and close the
door. When the error clears, redo Steps 5 and 6.
The display shows the self-clean cycle status:
• The clean symbol indicates that self-clean is in process.
• The lock symbol indicates that the door is latched.
• “ON” indicates that the heating elements are on.
To stop self-cleaning, tap CANCEL/SECURE. The oven door
symbol disappears from the display). The oven may still be
hot, so be cautious.
When self-cleaning is complete:
• The door latch releases when the inside has cooled
down. The Clean icon, Lock icon, and ON indicator disap-
pear from the display. The oven, however, is still HOT.
•
•
cleaning. When the oven is cool, wipe up the residue with a
damp cloth or sponge.
Setting Delayed Self-Cleaning
1. Prepare the oven for self-cleaning as instructed in the previ-
ous procedure, and close the oven door.
2. Tap SELF CLEAN > START TIME.
3. On the numeric keypad, enter a start time (e.g., for 12:30, tap
1-2-3-0).
Maximum delayed start period is 22 hr, 59 min.
4. Tap START/CONTINUE.
DELAY appears on the display; the oven door locks. Self-
cleaning will start at the set time.
When the oven is set for time-delay self-cleaning:
• you can tap CLOCK to view the time of day; with the clock is
displayed), you can tap START TIME to view the self-cleaning
start time.
• when self-cleaning starts, DELAY disappears from the display,
and ON appears.
To cancel time-delay self-cleaning, tap CANCEL/SECURE.
If Then
self-cleaning has not
started,
allow 1 minute for the door to unlock before
using the oven.
self-cleaning has
started,
the oven door unlocks when the oven cham-
ber has cooled somewhat—the oven will still
be about 400°F (205°C).
1 2
1 2
CARE AND CLEANING
Loading ...
Loading ...
Loading ...