Loading ...
Loading ...
Loading ...
Faults and what to do about them. en
61
Information on the display panel
Indicator Cause/remedy
- P - and ÿ The door is unlocked. It is possible to add laundry.
- P - ■ The temperature is too high. Wait until the temperature drops.
■ The water level is too high. It is not possible to add laundry. Close the door
immediately, if necessary. Press the A button to resume the programme.
ÿ is flashing ■ Laundry may be trapped. Open and close the door again and press the A
button.
■ If necessary, push the door closed or remove the trapped laundry and then
push it closed again.
■ If necessary, switch the appliance off and then on again; set a programme and
apply the settings you require; start the programme.
ù is flashing The detergent drawer has not been pushed in fully. Push the drawer in correctly.
r is lit continuously ■ Turn the tap on fully,
■ The supply hose is kinked/trapped,
■ The water pressure is too low. Clean the filter. ~ Page 59
E:18 ■ The drain pump is blocked. Clean the drain pump. ~ Page 58
■ The drain hose/drain pipe is blocked. Clean the drain hose at the siphon.
~ Page 59
E:23 There is water in the base trough; the appliance is leaking. Turn off the tap. Call the
after-sales service. ~ Page 64
E The childproof lock is activated – deactivate it. ~ Page 43
Å is lit
continuously
Too much foam has been detected and additional wash cycles have been
activated. Add less detergent to the next wash cycle with the same load.
The indicator light for
the Drum Clean
programme* is
flashing
* Depending on the
model
Run the Drum Clean 90 °C programme or a 60 °C programme to clean and care
for the drum and the outer tub.
Notes
■ Run the programme without laundry.
■ Use standard washing powder or a detergent that contains bleach. To prevent
foaming, only use half the amount of detergent recommended by the detergent
manufacturer. Do not use detergents intended for woollens or delicates.
■ Switching the information signal on/off ~ Page 54
| Off: Wi-Fi is switched off and the appliance is not connected to your home network.
Flashing: The appliance is trying to connect to your home network.
Continuously lit: Wi-Fi is switched on and the appliance is connected to your
home network.
Other indicators Switch off the appliance, wait for 5 seconds and then switch it back on. If the
indicator appears again, call the after-sales service. ~ Page 64
Loading ...
Loading ...
Loading ...