Loading ...
Loading ...
Loading ...
Visit Radioddity.com For Downloads And Help
15
Visit Radioddity.com For Downloads And Help
16
VOX
This function is not necessary to push the PTT on the transceiver for a
transmission. Transmission is activated automatically by detecting the radio
voice. When finish speaking, the transmission automatically terminated and
the transceiver will automatically receive signal. Be sure to adjust the VOX
Gain level to an appropriate sensitivity to allow smooth transmission.
Operation: Menu---- VOX Level---Select OFF/1/2/3---MENU----EXIT
VOX Delay
When the VOX is enabled, set up the VOX delay to help to extend the
transmission time to avoid stopping a transmission too early.
Operation: Menu---Setting--- VOX Delay---Select 0.5~2S--MENU----EXIT
FM Radio
In standby, short press side key to turn on FM Radio.
FM range: 65-76/76-108MHz.
Note: In FM Radio mode, press [MENU] key to switch a FM frequency, and program
the FM frequency through the numeric keys.
Scan
In standby, long press [#] key to turn on scan function, it supports channel
list scan and frequency steps scan.
Operation: Menu--- Setting --- Scan Mode --- Select Time / Carrier / Search
--- MENU --- EXIT.
Time Operation (TO): Scanning will stop when it detects an active signal, and
after 5s, it resumes scanning.
Carrier Operation (CO): Scanning will stop when it detects an active signal,
until the active signal disappears, and after 5s, It resumes scanning.
Search Operation (SE): Scanning will stop after it detects an active signal.
Note: In channel mode, scanning the channel numbers in the channel list. In
frequency mode, scanning in frequency steps.
Dual Standby
After turn on dual standby function, you can wait two channels signals from
Band A and Band B at the same time.
Operation: Menu----Advanced Setting----Dual Standby----Select OFF/ON---
Menu----EXIT
SOS
SOS function supports three modes: On site/Send sound/Send code.
On Site: The radio emits an alarm tone and does not send out signals to others.
Send Sound: Transmit the alarm sound through the signal.
Send Code: Transmit the alarm code through the signal.
Long press PF1(flashlight key) to turn on SOS mode.
Operation: Menu-- Advanced Setting --SOS mode----Select on site / send
sound / send code--Menu----EXIT.
CTCSS & DCS
CTCSS/DCS (Continuous Tone Coded Squelch System) / (Digital Coded
Squelch)
Some times when you're working with larger groups of people using the same
channel, things can get very crowded. To minimize this problem, CTCSS/DCS
code will help you block out unwanted transmissions on your frequency have
developed.
Operation: Menu --- CTCSS /DCS Setting --- Receive CTCSS / Receive DCS
/ Transmit CTCSS / Transmit CTCSS / Transmit DCS / encryption--- (OFF/67.0
-254.1) / (OFF/023-754) (OFF/67.0-254.1) / (OFF/023-754) / (OFF/ON) ---
Menu ---- EXIT.
Loading ...
Loading ...
Loading ...