Loading ...
Loading ...
Loading ...
13
Complete Installation
1. Plug the optional remote up/down switch into the front panel
of the vent box.
2. Use cable tie mounting bases and cable ties to rout the
switch wiring to an easily accessible area near the front inside
of the cabinet.
3. Use 2 screws to secure the remote up/down switch housing
to the cabinet.
4. Connect vent system to blower. Vent system must end with
a wall or roof cap. Use clamps or duct tape to seal all joints.
Grounding Instructions
This appliance must be grounded. In the event of an electrical
short circuit, grounding reduces the risk of electric shock by
providing an escape wire for the electric current. This appliance
is equipped with a cord having a grounding wire with a grounding
plug. The plug must be plugged into an outlet that is properly
installed and grounded.
WARNING: Improper grounding can result in risk of electric
shock.
Consult a qualified electrician if the grounding instructions are
not completely understood or if doubt exists as to whether the
appliance is properly grounded.
Do not use an extension cord. If the power supply cord is
too short, have a qualified electrician install an outlet near
the appliance.
NOTE: The grounded 3 prong outlet shall be located below
the cooktop surface and cannot be placed in a closed cabinet
without any access. Route the power cord beneath the
downdraft vent system and away from the heat generated by
the cooktop of other appliances.
1. Plug 3 prong power cord into a grounded 3 prong outlet
located inside the cabinet where the downdraft vent is
mounted.
2. Use the remote control or the remote up/down switch to raise
the vent hood. (See the “Remote Control Operation” section.)
If the vent hood does not rise, check that the circuit breaker
has not tripped or a household fuse blown.
3. Remove packing material.
4. Install filters. See “Filters” in the “Vent System Care” section.
5. Install glass. See “Glass” in the “Vent System Care” section.
A. Remote up/down switch connector
B. Remote up/down switch
A
B
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
Loading ...
Loading ...
Loading ...