Loading ...
Loading ...
Loading ...
4
INSTALLATION REQUIREMENTS
Flat-blade screwdriver #2 Phillips screwdriver
Wire stripper (direct wire
installations)
Tin snips (new vent
installations)
1/4" nut driver
(recommended)
Vent clamps
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
Caulking gun and
compound (for installing
new exhaust vent)
Utility knife
Tape measure Pliers
Level
Parts supplied (all models):
Leveling legs (4)
Tools needed for all installations:
Parts package is located in dryer drum. Check that all parts
are included.
Check local codes. Check existing electrical supply and venting,
and read “Electrical Requirements” and “Venting Requirements”
before purchasing parts.
Check code requirements. Some codes limit, or do not permit,
installing dryer in garages, closets, mobile homes, or sleeping
quarters. Contact your local building inspector.
Mobile home installations require metal exhaust system
hardware, available for purchase from the dealer from whom you
purchased your dryer. For further information, please reference
the “Assistance or Service” section of the “Use and Care Guide”.
TOOLS AND PARTS
Gather the required tools and parts before starting installation.
“Y” connector
Short inlet hose
Long inlet hose
Rubber washer
Tools needed for gas installations:
8" or 10" pipe wrench
8" or 10" adjustable wrench
(for gas connections)
Pipe-joint compound
resistant to LP gas
Loading ...
Loading ...
Loading ...