Loading ...
Loading ...
Loading ...
PROBLEM
Dishwasher
will not start
Dishwasher
will not fill
with water
CAUSE
•Dishwasher not
receiving electricity
•Dial not in correct
position for cycle
selected
•Turning the Dial
too far
.Turning the Dial
too far
•No water supply
•Water inlet valve
clogged
- improper loading
SOLUTION
• Check house fuse or circuit breaker_
• Make sure Dial is turned far enough and cycle button is fully pushed in_
•Turn Dial to START, Be careful you do not turn the Dial any farther than
necessary_ There is a delay between start-up and water fill, so you will not
hear any wash action right away.
. See the solution above
•Make sure water supply valve under sink is turned onr
•Water valve supply line may be clogged with sediment. Clean out_
Unusual . Utensils may not be secure on rack pins, or something small may have
noise dropped from the rack, Water is causing utensils to rattle, Make sure
everything is securely placed in dishwasher.
Dishwasher •Dishwasher not •Level dishwasher as described in Installation Instructions, Don't pIace
leaks level dishwasher on carpet,
•Too much sudsing
Dishes
not dry
i
• Spilled rinse agent
• Dishwasher door
interferes with
surrounding
cabinets
•Water is not hot
•AIR DRY
oPtion selected
: improper loading
•Rinse agent
dispenser empty
•Improper detergent. Use automatic dishwasher detergent only or try
a different brand or less detergent.
•If hand dishwashing detergent is used by mistake, pour one measuring cup
of vegetable oil in bottom of tub and run dishwasher through a complete
NORMAL WASH cycle with recommended amount of automatic dishwashing
detergent,
• To remove suds from tub: Open dishwasher. Let suds evaporate_ Add
1 gallon of cold water to tub, Close and latch dishwasher. Pump out water
by slowly turning Dial until a drain period is reached. Repeat if necessary,
•Spilled rinse agent can cause foam during washing. This can lead to
overflowing, Wipe up accidental spill of rinse agent with a damp cloth
• Make sure door does not touch cabinets when opening or closing.
Use leveling togs to level dishwasher.
•Raise water heater thermostat to 140°F if necessary.
•Do not select AIR DRY option. Allow dishes to dry in heated air,,
• Load dishes so items drain properly,Avoid overloading.
• Fill rinse agent dispenser if empty,
Z
Loading ...
Loading ...
Loading ...