Loading ...
Loading ...
Loading ...
the area around the recessed grips. Make
sure that the trim does not become stuck.
4. Carefully swing out the trim.
Replacing the reversing lamp and inner
brake lamp
1. Loosen the two holders, arrow 1 and pull
down on the lamp holder to remove, ar‐
row 2.
2. Unscrew the defective bulb of the revers‐
ing or brake lamp from its socket counter‐
clockwise.
3. Insert the new bulb.
Installing the bulb holder
1.
Slide the bulb holder onto the two guide
pins, arrow 1. Insert the two contacts, ar‐
row 2, into the connections, arrow 3.
2. Press on the bulb holder. Make sure that
the two exterior holders latch into place.
3. Swing the trim back onto the trunk lid and
secure.
Rear lamp, license plate lamp and
central brake lamp
Follow general instructions, refer to page 212.
These lights are made using LED technology.
Contact your service center in the event of a
malfunction.
Changing wheels
Hints
When using run-flat tires or sealants, a tire
does not need to be changed immediately in
the event of pressure loss due to a flat tire.
Which is why no spare tire is available.
The tools for changing wheels are available as
accessories from your service center.
Jacking points for the vehicle jack
The jacking points for the vehicle jack are lo‐
cated at the positions shown.
Vehicle battery
Maintenance
The battery is maintenance-free.
The added amount of acid is sufficient for the
service life of the battery.
Further information about the battery can be
obtained from your service center.
Seite 220
Mobility Replacing components
220
Online Edition for Part no. 01 40 2 960 440 - II/15
Loading ...
Loading ...
Loading ...