Loading ...
Loading ...
Loading ...
Installation
8
ENGLISH
Feed water tube
Door removal
Remove the
freezer
compartment
door
Remove lower
cover and then
feed water tube
Remove the
refrigerator
compartment
door
1) Remove the hinge cover by loosening
the screws. Then separate all
connection wires except for the earth.
Remove the lower cover by loosening all the screws. Then push in the feed water tube
while depressing the connector , as shown in the illustration on the right.
2) Remove the keeper by rotating it counter clockwise
(c) and then lifting the upper hinge up (d).
3) Remove the freezer compartment door by lifting it
upward. The door should be lifted high enough for the
feed water pipe tube to be completely pulled out.
1) Loosen the hinge cover screws and
remove the cover. Remove connection
wires, if any, except for the earth line.
•
When removing the upper hinge, be careful that
the door does not fall forwards.
NOTE
•
If you have removed the refrigerator compartment
door to pass the appliance through an access door, lay
the door down, but be careful not to damage the feed
water pipe tube.
NOTE
•
If a tube end is deformed or abraded, trim the end with sharp knife until perfectly round.
NOTE
Keeper
Upper hinge
Connection
wires
Hinge cover
Upper hinge
Electric Shock Hazard
Disconnect electrical supply to refrigerator before
installing. Failure to do so could result in death or
serious injury. If your front door is too narrow to get
the refrigerator into the house, remove the refrigerator
doors and pass the appliance through laterally.
Lower hinge
Engough for
water feed pipe
tube to be completely
pulled out
Connection
wires
Applicable to No Plumbing
Ice & Water Model only
Lower cover
Feed water tube
Loading ...
Loading ...
Loading ...