Loading ...
Loading ...
Loading ...
18
3. Apply masking tape to the end of a
9
⁄
32
” (7 mm) nut driver to
help hold the gas orifice spud in the nut driver while
changing it. Press nut driver down onto the gas orifice spud
and remove by turning it counterclockwise and lifting out.
Set gas orifice spud aside.
4. Gas orifice spuds are stamped with a number on the side.
Replace the Propane gas orifice spud with the correct
Natural gas orifice spud.
Refer to the following chart for the correct Natural gas orifice
spud placement.
Natural Gas Orifice Spud Chart
Burner Rating Color Size
ID
Number
18,000 BTU
Yellow/Blue 2.16 mm N216
17,000 BTU
Red/Magenta 2.10 mm N210
15,000/15,500 BTU
Red/Black 2.00 mm N200
14,200 BTU
Red/Orange 1.90 mm N190
13,000/13,500 BTU
Red/Blue 1.85 mm N185
12,000/12,500 BTU
Red/Yellow 1.80 mm N180
9,500 BTU
Red/Brown 1.55 mm N155
8,000 BTU
Red/White 1.40 mm N140
5,000 BTU
Red/Brass 1.10 mm N110
NOTE: Refer to the Model Number and Serial Number Plate
located on the oven frame behind the top left side of the oven
door for proper sizing of spuds for each burner location.
5. Place Propane gas orifice spuds in plastic parts bag for
future use and keep with package containing literature.
6. Replace the burner base using both screws.
7. Replace burner cap.
8. Repeat steps 1-7 for the remaining burners.
To Convert Oven Bake Burner (Propane Gas to
Natural Gas)
1. Remove the oven racks.
2. Remove 2 screws at the rear of the oven bottom.
3. Lift the rear of the oven bottom up and back until the front of
the panel is away from the front frame. Remove from oven
and set it aside on a covered surface.
4. Remove 2 screws from the front tabs of the flame spreader.
Lift front of the flame spreader and pull forward to remove
tabs from rear of oven and set it aside on a covered surface.
5. Remove 2 screws from the bake burner.
6. Slide the front of the bake burner to the side to remove tab
from front of oven. Lift the back of the bake burner off the
oven orifice, and set the bake burner aside.
7. Use a ³⁄
8
” (1 cm) nut driver or combination wrench and turn
the Propane gas bake burner orifice spud counterclockwise
to remove. The spud will be stamped with a “57.”
B
A
C
D
A. Orifice spud
B. Orifice spud holder
C. Screw
D. Spark electrode
XXX
A
A. Stamped number
A
B
A. Screws
B. Oven bottom
A
B
A. Screws
B. Flame spreader
A
B
A. Screws
B. Bake burner
Loading ...
Loading ...
Loading ...