Loading ...
Loading ...
Loading ...
4
Meteor
Original Instructions
grasping the plug, not by pulling at the cable.
Activate the cable rewinder.
3.2 Connecting hose, tube and
nozzles
1. Insert the hose connector into the suction inlet.
2. Connect the bent tube to the tube.
3. Connect the tube to the nozzle.
4. The tube is telescopic and can be adjusted
to your height. Push the adjusting button to
extend the tube and pull back to shorten to
desired length.
Container full indication
On the control panel a lamp is placed, where you
will receive notication, when the container is full
or the suction is degraded otherwise.
The dust container must be emptied if the lamp
is constantly on when the machine is operating
at maximum power and the nozzle is raised from
the oor.
3.3 Releasing and emptying of dust
container
The dust container can be separated from the
machine for emptying. Simply release the dust
container from the machine by pressing the but-
tons on the dust container handle (see illustration
below) and pull the dust container upwards. The
dust container can now be emptied in a dustbin,
by pressing the lever marked “Push”.
3.4 Cleaning the cyclone lter
The cyclone lter should be cleaned regularly
to maintain suction. You will have access to the
cyclcone lter when you have released the dust
container. If necessary, use lukewarm water.
Make sure to let the lter dry before putting it
back into the vacuum cleaner.
3.5 Changing the exhaust lter
Open the cover for the exhaust lter, as seen in
the overview image (page 2), replace the lter
with a new one and close the cover again.
3.6 Washing/exchanging the EPA
lter
You will have access to the EPA lter when you
have released the dust container.
Rinse the inside of the lter using lukewarm
tap water. Do not use any cleaning agents and
avoid touching the lter surface. Tap the lter to
remove the excess water. Make sure to let the
lter dry before putting it back into the vacuum
cleaner.
If necessary, exchange the lter.
Please note that the machine will not function
without a EPA lter.
3.7 Parking the tube and nozzle
There are two grooves for parking. One located
on the underside to use when machine stands on
the back, and the other on the back to use when
the machine is standing on the wheels.
3.8 Thermal fuse
The machine is tted with a thermal fuse, which
prevents the machine from overheating. If the
thermal fuse blows, the machine automatically
switches o the motor and must cool before it
can be started again.
Restart
1. Turn o the machine and unplug from the wall
socket.
2. Make sure that nothing blocks the air ow
through the bent tube, hose, tube, nozzle or
lters.
3. Let the machine cool.
4. Plug in the machine again and push the start
button. The machine will not start until cool
enough. If the machine does not start turn it
o and unplug. Try again in a while.
4. Cleaning tips
Adjust the suction power by means of the power
regulation or the sliding valve on the bent tube.
Upholstery nozzle (13)
Use the upholstery nozzle for upholstered furni-
ture.
On/o
switch
Adjust suction power
Cable
rewinder
Container full
indication
Loading ...
Loading ...
Loading ...