User Manual - Page 8

For GLD4260L00SS. Series: EDW5000 Series EDW6000 Series GHDA400 Series GHDA650 Series GLD4100 Series GLD4200, GLD4300, GLD5500 , GLD5800,GLD6200 , GLD6300, GLD6500 ,HLD4000 ,

Loading ...
Loading ...
Loading ...
Dish Preparation Prior to Loading
No pre-rinsing of normal food soil is required.
Scrape off hard soils, including bones,
toothpicks, skins and seeds.
Remove large quantities of any remaining
food.
Remove leafy vegetables, meat trimmings
and excessive amounts of grease or oil.
Remove acidic food soils that can discolor
stainless steel.
8
Operating Instructions Safety Instructions
Consumer Support
Troubleshooting Tips
Using the dishwasher.
Check the Water Temperature
Use Jet-Dry
®
or Cascade Crystal Clear
®
Rinse Agent
Jet-Dry
®
or Cascade Crystal Clear
®
rinse agents remove spots and prevent new film buildup on
your dishes, glasses, flatware, cookware and plastic.
Filling the Dispenser
The rinse agent dispenser holds 3.5 oz. of rinse agent. Under normal
conditions, this will last approximately one month. Refill when rinse agent
is not visible in the indicator. Do not overfill.
Make sure the dishwasher door is fully open.
Turn the dispenser cap to the left and lift it out.
Add rinse agent until the indicator window looks full. Do not overfill.
Clean up any spilled rinse agent with a damp cloth to prevent foam.
Replace the dispenser cap.
Rinse Aid Setting
The amount of rinse agent released into the final wash can be
adjusted. The factory setting is at the midpoint. If there are rings of
calcium (hard water) spots on dishes, try a higher setting. If you
observe foam in the final rinse, try a lower setting.
To adjust the setting
Remove the dispenser cap, then turn the adjustable setting dial
counterclockwise to increase the amount of rinse agent or clockwise
to reduce the amount of rinse agent dispensed.
5
4
3
2
1
The entering water should be at least 120°F and
not more than 150°F, for effective cleaning and to
prevent dish damage. Check the water temperature
with a candy or meat thermometer. Turn on the hot
water faucet nearest the dishwasher, place the
thermometer in a glass and let the water run
continuously into the glass until the temperature
stops rising.
M
i
n
M
a
x
Indicator
Dispenser cap
Adjustable setting dial
Loading ...
Loading ...
Loading ...