Loading ...
Loading ...
Loading ...
TO LOCK MOTOR HEAD IN RAISED POSITION
• Push locking lever up into UNLOCK position
and hold.
• Tilt motor head back.
• Move locking lever into LOCK position.
TO LOCK MOTOR HEAD IN OPERATING
POSITION
• Push locking lever up into UNLOCK position
and hold.
• Lower motor head until it is completely
down into operating position.
• Move locking lever into LOCK position.
• Before mixing, test motor head lock by
attempting to raise head.
NOTE: Motor head should always be kept
in LOCK position when using mixer.
TO OPERATE CONTROL SPEED
• Speed control lever should always be set
on lowest speed for starting, then gradually
moved to desired higher speed to avoid
splashing ingredients out of bowl. See
“Speed Control Guide.”
0
1
2
4
6
8
1
0
English
5
TO ATTACH BOWL
• Be sure speed control is OFF.
• Tilt motor head back.
• Place bowl on bowl-clamping plate.
• Turn bowl gently in clockwise direction
(see picture above).
• Sit pouring shield on bowl.
TO REMOVE BOWL
• Turn speed control to OFF.
• Tilt motor head back.
• Turn bowl in counterclockwise direction.
TO ATTACH FLAT BEATER,
WIRE WHIP, OR DOUGH HOOK
• Turn speed control to OFF and unplug.
• Raise motor head.
• Slip beater onto beater shaft and press
upward as far as possible.
• Turn beater to right, hooking beater
over pin on shaft.
TO REMOVE FLAT BEATER,
WIRE WHIP, OR DOUGH HOOK
• Turn speed control to OFF and unplug.
• Raise motor head.
• Press beater upward as far as possible and
turn left.
• Pull beater from beater shaft.
K
i
t
c
h
e
n
A
i
d
S
t
.
J
o
s
e
p
h
,
M
i
c
h
i
g
a
n
,
U
S
A
0
1
2
4
6
8
1
0
OFF
ON
Loading ...
Loading ...
Loading ...