Loading ...
Product dimension, cutout and installation specifications are provided for planning purposes only. Before installing
any product, be sure to verify cutout dimensions and electrical/gas connections as actual product dimensions may vary.
JENN-AIR
®
DETAILED PLANNING DIMENSIONS
2 of 4
JRC120031A 07/2012
36" GAS COOkTOP
JGC1536AD – 36" x 5
1
⁄4" x 21"
OPENING/CLEARANCE DIMENSIONS
MODEL # JGC1536AD
in cm
A
Width of combustible area above
cooking surface (min.)
36 91.4
B
Width from cooktop to fixed wall
or other combustible material (min.)
6 15.2
C*
Height to bottom of uncovered wood or
metal cabinet above cooking surface (min.)
30 76.2
D
Height to bottom of uncovered wood
or metal cabinet (min.)
18 45.7
E
Height to top edge of electrical and gas
installation area
3
7
⁄8 9.7
F
Depth of upper cabinet (recommended) 13 33.0
G
Depth from cutout to wall (min.) 1 2.5
H
Width of cutout 34
1
⁄2 87.6
I
Depth of cutout 19
7
⁄8 50.6
J
Depth from cutout to front of countertop 2
1
⁄8 5.4
e
Recommended electrical access location
g
Recommended gas supply line location
* Dimension can be reduced by 6" (15.2 cm) when bottom of wood or metal cabinet
is covered by not less than
1
⁄4" (0.6 cm) flame retardant millboard covered with not
less than No. 28 MSG sheet metal, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm)
aluminum or 0.020" (0.5 mm) copper.
If installing a hood or microwave hood combination above the cooktop, follow the
hood or microwave hood combination instructions for dimensional clearances above
the cooking surface.
GAS REQUIREMENTS
Natural Gas
This cooktop is factory-set for use with natural gas.
LP Gas Conversion
Conversion must be done by a qualified service technician. To convert
to LP gas, use the LP gas conversion kit provided with the cooktop.
ELECTRICAL REQUIREMENTS
120 volt, 60 Hz, AC only, 15-amp fused, grounded circuit is required.
A time-delay fuse or dedicated circuit is recommended. Minimum power
cord length is 46" (117.0 cm).
LOCATION REQUIREMENTS
• To ensure cooktop base clearance, cabinet side walls need to be wider
than the cutout.
• If cabinet has a drawer, allow a 4" (10.2 cm) minimum clearance between
countertop and top of drawer. Drawer depth may need to be shortened to
avoid interfering with the regulator.
COOKTOP OVER SINGLE WALL OVEN INSTALLATION
REQUIREMENTS
• For approved model number combinations, refer to the under counter
label on the bottom of the cooktop burner box.
• To install a cooktop over a 30" single wall oven, refer to page 3.
FRONT VIEW
C*
F
D
A
B
B
H
J
I
G
e
Side
Cabinet
G
E
g
TOP VIEW – CUTOUTSIDE VIEW
C* F
D
A
B
B
H
J
I
G
e
Side
Cabinet
G
E
g
C*
F
D
A
B
B
H
J
I
G
e
Side
Cabinet
G
E
g
Loading ...
Loading ...