Loading ...
Loading ...
Loading ...
21
GB
Description
1. Steam control button
2. Iron temperature control slide
3. Iron thermostat light
4. Ultracord system (depending on model)
5. Iron rest
6. Illuminated on / off switch
7. Electric cord rewind button (depending on
model)
8. Power cord storage space
9. Power cord and plug
10. Turbo button (depending on model)
11. Lock-System hoop (depending on model)
12. Removable water tank
13. Removable water tank handle
14. Steam generator boiler (in the base unit)
15. Iron-base steam cord
16. Slide storage place for the steam cord
17. Anti-scale valve cap
18. Anti-scale valve
19. Control panel
a. “Water tank empty” light
b. “Auto off” light
c. Restart button
d. “Anti-calc” light
e. “Reset” button
f. “Steam ready” light
g. Steam output control dial
Locking system for retaining the iron on the base - Lock-system
(depending on model)
• Your steam generator is equipped with a retaining hoop which locks the
iron on its base for easier transport and storage – fig.1:
- Locking – fig.2
- Unlocking – fig.3
• To carry your steam generator by the iron handle:
- Place the iron on the iron rest of the generator and raise the retaining hoop
over the iron until it locks into place (audible
click) – fig.2.
- Grasp the handle of the iron to carry your steam generator – fig.1.
Preparation
What water may be used ?
• Your iron has been designed to operate using untreated tap water.
• Heat concentrates the elements contained in water during evaporation. The
types of water listed below contain organic waste or mineral elements that can
cause spitting, brown staining or premature wear of the appliance: water from
clothes dryers, scented or softened water, water from refrigerators, batteries or
air conditioners, pure distilled or demineralised water or rain water should not
be used in your iron. Also do not use boiled, filtered or bottled water.
Filling the water tank
• Place your steam generator on a stable, horizontal heat-resistant surface.
• Remove the water tank by pulling on the handle (at the front of the
generator) – fig.4.
• Fill the tank with water, taking care not to exceed the maximum level –
fig.6. and fig.7.
• Slide the tank back into its housing until its “clicks” into place – fig.5.
If you have very hard water,
it is recommended that you
mix tap water with purified
(bottled) water in the
following ratio:
- 50% tap water,
- 50% purified (bottled)
water.
1800118261 GTH GV8330-8360 ok_110x154 11/02/10 15:00 Page21
Loading ...
Loading ...
Loading ...