Loading ...
Loading ...
Loading ...
8
Freezing protection
With the knob of the thermostat (
B
) in position and one of
the power levels selected, the appliance will maintain the room
at a temperature of about 41°F (5°C) preventing freezing with
minimum energy consumption.
Models with fan
The appliance is equipped with a fan that provides even more
rapid and uniform heating.
To start this function, turn the power selector (
C
) to Max .
Models with 24-hour timer
When the appliance is connected to the power supply the timer
is always active so as to stay synchronized with the local time.
To operate the appliance without timer, position the timer
slider (
D
) to
.
To operate the appliance at the times set, position the timer
slider to (Fig. 1) and proceed as follows:
•
Check the time on your clock or watch. If it is 10.00 for
example, turn the numbered programmer disk until the
number 10 coincides with the pointer marked on the
programmer device.
•
Set the periods of time during which you want the
appliance to operate by pushing the teeth outwards (see
figure). Each tooth corresponds to a period of 30 min. At
the end of the procedure, the sectors corresponding to the
periods of operation will be visible.
•
In this way, the appliance will function automatically
each day at the times set. (Important: the appliance must
always be connected to the power supply).
•
To modify the settings, return the teeth to the initial
position and set the new operating periods.
•
To turn the appliance off, turn the power selector to "0".
SAFETY FUNCTIONS
-
Safety device:
The appliance is fitted with a safety
cutoff device which will switch the appliance off in case
of accidental overheating. To reset the cutoff, disconnect
the plug from the power supply for a few minutes,
remove the cause of overheating, then reconnect the
appliance. If this abnormal situation happens several
times, contact customer service.
-
Tip-over safetydevice:
This device turns the appliance
off if it falls over or is positioned inappropriately in such
a way as to jeopardize safety. The appliance resumes
operation a few seconds after being placed in an upright
position again.
MAINTENANCE
Before carrying out any maintenance, disconnect the appliance
from the power supply and wait for it to cool down completely.
This appliance requires no particular maintenance.
It is sufficient to remove dust with a soft, dry cloth. Never use
abrasive powders or solvents. If necessary remove areas of
concentrated dirt with a vacuum cleaner.
TROUBLESHOOTING
PROBLEM
CAUSE
SOLUTION
The appliance doesn’t
work
The plug is not inserted properly into the
power socket or the socket switch is off.
The power selector is in the ”0”position.
The thermostat is set too low.
Timer setting.
The tip-over switch has been activated.
Insert the plug into the power socket and
switch on if necessary.
Move the power selector to position MIN, MED,
MAX or MAX .
Turn the thermostat knob clockwise to higher
settings until the heater restarts.
Make sure the timer is correctly set to local
time and check the position of the teeth.
Make sure the appliance is standing upright
on a flat surface, if the problem persists
contact our toll free number to assist you.
The alarm sound and the
appliance doesn't work
Check for any obstruction.
Remove the obstruction, disconnect the
power plug of the heater and let the appliance
cool down. If the appliance doesn't work
please contact the De longhi toll free number.