Loading ...
Loading ...
Loading ...
15
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
re, or electrical shock.
WARNING
If you experience Possible Causes Solution
Washer not performing as expected (cont.)
Washer won’t run or ll,
washer stops working
(cont�)
Check proper electrical supply� Plug power cord into a grounded 3-prong outlet�
Do not use an extension cord�
Ensure there is power to outlet�
Reset a tripped circuit breaker� Replace any blown fuses�
NOTE: If problems continue, contact an electrician�
Normal washer operation� Lid must be closed for washer to run�
Washer will pause during certain phases of cycle� Do not interrupt
cycle�
Washer may be stopped to reduce suds�
Washer may be tightly packed� Remove several items, rearrange load evenly around the
washplate� Close lid and touch and hold START/PAUSE/Unlock
Lid�
Add only 1 or 2 additional items after washer has started�
Do not add more water to the washer�
Not using HE detergent or using too
much HE detergent�
Only use HE detergent� Suds from regular detergents can slow
or stop the washer� Always measure detergent and following
detergent directions based on your load requirements�
To remove suds, cancel cycle� Select RINSE & SPIN� Select your
cycle� Touch and hold
START/PAUSE/Unlock Lid
� Do not add more
detergent�
Washer not draining/
spinning, loads are still
wet
Small items may have been caught
in pump or between basket and tub,
which can slow draining�
Empty pockets and use garment bags for small items�
Using cycles with a lower spin speed� Cycles with lower spin speeds remove less water than cycles with
high spin speeds� Use the recommended cycle/speed spin for your
item�
If you experience Possible Causes Solution
Washer not performing as expected (cont.)
Washer won’t run or ll,
washer stops working
Check for proper water supply� Both hoses must be attached and have water owing to inlet
valve�
Both hot and cold water faucets must be turned on�
Check that inlet valve screens have not become clogged�
Check for any kinks in inlet hoses, which can restrict water ow.
TROUBLESHOOTING
First try the solutions suggested here or visit for assistance and to possibly avoid a service call�
Loading ...
Loading ...
Loading ...