Loading ...
2
2. Move the door strike
Using a Torx
®†
T25 screwdriver, remove the 2 screws securing
the door strike to the door frame of the dryer. Remove the 4
screws above and below the door strike and set aside for later
use. Rotate the strike 180° and attach to the opposite side of
dryer door frame, as shown.
† ® TORX is a registered trademark of Saturn Fasteners, Inc.
Not used on all models
3. Remove inner door from outer door
Position the door with the inside of the door facing up.
Using a Phillips screwdriver, remove the 13 screws (17 screws
on some models) securing the inner door to the outer door.
Lift off the inner door and set aside.
NOTE: There is a small release tab on each side of the door.
If the inner and outer door do not separate easily, slide a
credit card, putty knife, or similar at object between the inner
and outer doors at the locations shown to release the tab.
Not used on all models
4. Remove outer door trim
On some models, you will need to use a Phillips screwdriver
to remove 4 screws attaching the outer door trim to the outer
door liner/window assembly. Lift off trim.
5. Remove door handle screws
Using a Phillips screwdriver, remove the 2 screws attaching
the outer window and door handle to the outer door liner and
remove.
Release tab
Release tab
W10315279Cv02.indd 2 7/20/11 11:01 AM
Loading ...
Loading ...
Loading ...