Loading ...
Loading ...
Loading ...
sharkclean.comsharkclean.com
CLEAN HEPA FILTER
EVERY YEAR
Press the Cover Latch above the Filter Cover,
then pull o the cover. Push the tab on the
front of the cover to detach the HEPA Filter.
To replace the HEPA filter, snap it back into
the pod, then slide-on the cover until it clicks
into place.
CLEAN PRE-MOTOR FILTERS
ONCE A MONTH
Remove Dust Cup, then lift out the Filter
Frame. Pull up the Foam Filter to remove it
from the filter frame. The Felt Filter is built
into the support frame.
To reinstall, insert the bottom of the dust cup
into the pod and tilt it until it clicks into place.
Regularly clean and replace the filters to keep your vacuum's suction power optimal.
To clean filters, rinse with cold water only. Allow all filters to air-dry for at least 24 hours before
reinstalling them to prevent liquid from being drawn into electricparts.
MAINTENANCE
CLEANING FILTERS
IMPORTANT: DO NOT use soap when cleaning the filters.
Foam Filter
Filter Frame
Cover Latch
HEPA Filter
Filter Cover
NOTE: To order replacement parts and filters, visit sharkaccessories.com.
Replacement
Pre-Motor Foam &
Filter Support Kit
Replacement
HEPA Filter
The Pre-Motor Filters should be replaced every 2.5 years. The HEPA Filter should be replaced every 3 years.
REPLACING FILTERS
MAINTENANCE
NOZZLE MAINTENANCE
CLEANING THE SOFT ROLLER
NOTE: For best performance, keep the Soft Roller clean with regular maintenance.
1 To remove the Soft Roller, slide the Eject Roller
button on the floor nozzle.
2 Tap loose debris o the Soft Roller. Use a dry
towel to wipe it clean, and to remove any debris
caught in the teeth behind the Soft Roller.
3
Hand-wash the Soft Roller as needed. Use only
water, and let it air-dry completely for at least
24 hours.
4
Reinsert the Soft Roller and press it in until it clicks
securely into place.
If you notice any hair wrap, continue
vacuuming and the Self-Cleaning Brushroll
will automatically remove it. If some hair
wrap remains after continued use, remove
the brushroll cover from the bottom of the
nozzle and use scissors to carefully cut away
the hair.
To remove the cover, use a coin to turn the
locks counterclockwise. Lift o the cover
and remove any debris or hair wrap. Check
the Debris Intake and clear away any dirt or
blockages.
To close the cover, push down until it clicks
into place, then turn the locks clockwise
until closed.
PRE-MOTOR FILTERS HEPA FILTER
Loading ...
Loading ...
Loading ...