Loading ...
Loading ...
Loading ...
en Fault, what to do?
44
Error code “:ƒ† is lit. Waste water pump blocked or
cover on the waste water pump is
not locked in position.
Clean pump and lock cover correctly.
~ "Waste water pump" on page 42
Error code “:ƒˆ is lit. Mains voltage too low. Not an appliance fault, have the mains
voltage and electrical installation checked.
A different error code is
indicated on the digital
display.
(“:‹‚ to “:„‹)
A technical fault has probably
occurred.
Switch off appliances with the ON/OFF
switch (. After a short time restart the
appliance.
If the problem recurs, turn off the tap and
pull out the mains plug.
Call customer service and mention the
error code.
Refill indicator for salt P
and/or rinse-aid H is lit.
No rinse aid. Refill rinse aid.
No salt. Refill with special salt.
Sensor does not detect salt
tablets.
Use different special salt.
Refill indicator for salt P
and/or rinse-aid H is not
lit.
Refill indicator switched off. Activation/deactivation (see chapter
“Water softening system/Special salt”
~ Page 15 or “Rinse aid” ~ Page 17).
There is still enough special
salt/rinse aid available.
Check refill indicator, levels.
Water is left in the
appliance at the end of the
programme.
Filter system or area under the
filters 1j is blocked.
Clean filters and area underneath.
Program has not ended yet. Wait until programme ends or reset.
Fault Cause Remedial action
Loading ...
Loading ...
Loading ...