Loading ...
Loading ...
Loading ...
Options
The light above the selected pad will be ON to indicate which OPTION has been selected.
HI TEMP RINSE Turns on the heater in all prerinse and final rinse cycles to help prevent
spotting on dishware. This option may be turned
ON
or
OFF
during the
wash cycle.
HI TEMP WASH Energizes the heater in all prewash fill cycles. Recommended for use with
heavily soiled dishes. Option may be turned
ON
or
OFF
during the wash cycle.
HEATED DRY Shuts off the drying heat options. Dishes air dry naturally and energy is
OFF
saved. You can prop the door open after the light goes
ON
below the word
CLEAN.
HEATED DRY Turns the heater on for fast drying. This option will extend the time to your
ON
wash cycle by 30 minutes.
NOTE:
This cannot be selected with
RINSE &
HOLD
cycle.
LOCK
When the
LOCK
pad is touched twice within three seconds, all pads become
inoperative.
You can lock the controls to prevent any selections from being made.
Or you can lock the controls after you have
started a cycle or selected DELAY
START so the cycle or DELAY START is not interrupted.
Children cannot accidentally start dishwasher by touching pads with
this option selected.
To unlock the pads after they have been locked, touch the
LOCK
pad twice
within three seconds. The light above the
LOCK
pad will turn off.
DELAY START You can delay the start of a wash cycle for up to six hours. Press and hold
the
DELAY START
pad to choose the number of hours you want to delay
the start of the cycle. The machine will count down and start automatically
at the correct time.
NOTE:
If you forget to latch the door, a reminder signal
will beep until you do so.
RESET To change a cycle after washing starts, touch the
START/RESET
pad to
cancel the cycle. After water is pumped out and motor stops, you can
reprogram and restart the dishwasher.
Customer ServiceTroubleshooting TipsOperating InstructionsSafety Information
Start
The light above the START/RESET pad will be ON to indicate that it has been selected.
Touch the
START/RESET
pad to begin the cycle. There is a time delay between
start-up and water fill so you will not hear any wash action right away.
The cycle is complete when the light is
ON
below the word
CLEAN.
NOTE:
The dishwasher remembers your last cycle so you don’t have to
reprogram each time. When the dishwasher is loaded and door latch is in
the locked position, the control panel lights will be
ON
and will display the
last settings you selected. If you don’t want to change any of the settings,
simply touch the
START/RESET
pad to begin the cycle.
Also, if a power failure occurs,
NORMAL
and
HEATED DRY ON
will
automatically be programmed. Make any new selections and touch the
START/RESET
pad to begin the cycle.
9
2
3
Loading ...
Loading ...
Loading ...