Loading ...
Loading ...
Loading ...
Use
29
ENEN
3 Use
3.1 Before first use
1. Remove all stickers and labels from the
kettle and clean the outside with a damp
cloth.
2. Remove the scale filter behind the spout
and wash it under running water.
3. Replace the filter in the correct position.
4. Remove the kettle from its base, press the
button to open the lid and fill it to the
maximum level.
5. Close the lid and place the kettle back
on its base. Check that the pre-set
temperature is 100°C (if this not the
case, see point 7 of section”3.2
Operation”), then press the START/
STOP key to start the boiling cycle.
6. Wait for the water to boil, then empty the
kettle, disposing of the boiling water
safely. Repeat this operation at least
three times.
Danger of electrocution
• Plug into a earthed 3-prong outlet.
• Do not remove the earth prong.
• Do not use an adapter.
• Do not use an extension cord.
• Failure to follow these instructions could
result in death, fire, or electrical shock.
This appliance can be operated
both at 50 Hz and at 60Hz
without any adjustment.
Hot surfaces
• Surfaces are liable to get hot.
Tips and suggestions for the user
• Do not use the kettle to heat anything
other than water – this would risk
causing severe damage to the
appliance.
• Only boil the quantity of water
required so as not to waste water,
electricity and your time.
• Always boil cold water to improve
the quality of your hot drinks.
To increase the appliance’s lifetime:
• Empty any remaining water from
the kettle after each use.
• Regularly remove any scale from
inside the kettle.
Any slight marks or rings inside the
kettle are normal and due to
functional inspections which are
performed on each unit before
packaging.
Loading ...
Loading ...
Loading ...