Loading ...
Loading ...
3
Installing the
pedestal
1.Open the pedestal drawer.
Remove the envelope taped inside the
drawer. This envelope contains four
#12 x 5/8" (1.6 cm) hex head sheet
metal screws that will be used in Step 4.
1.Position the packaged washer/dryer
close to the final location. Using a utility
knife, cut through the packaging along
the dotted lines around the packaging
near its base. Note: Do not remove the
packaging at this time.
2.Remove the Phillips head screw
from both drawer slides and save
screws. Remove the drawer from the
slides and set aside. Push the slides
back into the pedestal.
9.Level the washer/dryer from side
to side and front to back. Make sure all
four pedestal feet are in solid contact
with the floor.
Place a level on the top. Locate the 1/4"
(6.4 mm) hex on the top of each
pedestal foot. Reach inside the
pedestal and use a 1/4" (6.4 mm) hex
head ratchet or open-end wrench to
adjust the feet up or down as needed to
level the washer/dryer.
7.Slide the washer/dryer close to
its final location.
If your washer/dryer is still in its
packaging, follow the instructions on
the packaging and remove it.
8.Follow the Installation
Instructions that came with your model
to finish installing or reinstalling your
washer/dryer (i.e., hoses, vents, etc.).
Excessive Weight Hazard
Use two or more people to move
washer or dryer.
Failure to do so can result in back
or other injury.
WARNING
If your washer or dryer is
still in its packaging:
Excessive Weight Hazard
Use two or more people to move
and install pedestal.
Failure to do so can result in back
or other injury.
WARNING
Follow these instructions to install the
pedestal on a washer or dryer.
cardboard
dryer bottom
install screws
washer bottom
3.If your washer/dryer has feet
installed, remove them. DO NOT install
the feet that came with a new
washer/dryer.
lower screws in
keyhole slots
cut along
dotted lines
2.Protect the floor with a large piece of
cardboard cut from the pedestal carton.
Lay the washer/dryer on its back (make
sure that the power supply cord is not
under the washer/dryer) so that the
cardboard is under the entire lower
back edge of the washer/dryer.
install screws
4.Partially install the two lower
#12 x 5/8” (1.6 cm) hex head sheet
metal screws leaving a space of about
3/8” (1 cm) between the screw head
and the bottom of the washer/dryer.
5.Move the pedestal against the
washer/ dryer bottom. Slide the
pedestal’s keyhole slots over the lower
two partially installed screws.
Position the pedestal toward the front of
the washer/dryer and install the two
remaining hex head sheet metal
screws. Do not tighten completely.
Align the sides of the pedestal so that
they are even with the sides of the
6.Tip the washer/dryer and
pedestal assembly back to upright
position. Remove protective cardboard.
washer/dryer. Reach inside pedestal
drawer opening and securely tighten all
four pedestal screws.
15"
(38.1 cm)
12"
(30.5 cm)
washer/dryer laying on its back
with packaging bottom removed
3.Remove the bottom of the packaging.
Go to “Installing the Pedestal”.
Loading ...
Loading ...
Loading ...