Loading ...
Loading ...
Loading ...
Cycle Completion Signal
1 Open the door and press the [On/Off] button.
2 Hold down the “A” button (see page 4) and press [Start] until the display indicates “H:00”.
3 Release both buttons.
4 Press the “A” button until the display shows “b:02”.
5 Press the “C” button to increase or decrease the tone “b:00” = OFF and “b:03” = LOUDEST
6 Press [Start] to save setting and close the door.
Intensive Drying
The final rinse uses a higher temperature which improves the drying results. The running time may increase slightly.
To turn intensive drying on:
1 Open the door and press the [On/Off] button.
2 Hold down the “A” button (see page 4) and press [Start] until the display indicates “H:00”.
3 Release both buttons.
4 Press the “A” button until the display shows “d:00”.
5 Press the “C” button to turn intensive drying on or off. “d:01” = ON and “d:00” = OFF
6 Press [Start] to save setting and close the door.
Auto Power Off
To save energy, the dishwasher is turned off 1 minute after the wash cycle ends. Auto Power Off can be
adjusted from P:00 to P:02.
To change the factory setting (P:01):
1 Open the door and press the [On/Off] button.
2 Hold down the “A” button and press [Start] until the display indicates “H:00”.
3 Release both buttons.
4 Press the “A” button until the display indicates “P:01”.
5 Press the “C” button until the display corresponds with your requirements.
P:00 = dishwasher does not turn off automatically
P:01 = dishwasher turns off automatically after 1 minute
P:02 = dishwasher turns off automatically after 120 minutes (2 hours)
6 Press [Start] to save the setting and close the door.
To change the language:
1 Open the door and press the [On/Off] button.
2 Hold down the “A” button and press [Start] until the display indicates “H:00”
.
3 Release both buttons.
4 Press the “A” button until the display indicates “L:01”.
5 Press the “C” button until the display corresponds with your requirements.
L:02 = English
L:03 = French
L:07 = Spanish
6 Press [Start] to save the setting and close the door.
Sapphire Glow®
The interior light comes on when the door is opened, even if the unit is powered off.
When the door is closed or slightly ajar, the interior light is off.
To change setting:
1 Open the door and press the ON/OFF button.
2 Hold down the A button and press and hold START until the display indicates “H:00”.
3 Release both buttons. The LED for the A button flashes and display indicates “H:00”.
4 Press the A button until the display shows “P:00” (factory setting or your previous setting).
5 Press the C button to switch between “P:00” = ON and “P:01” and “P:02” = OFF and press START
to save the setting and close the door.
Loading ...
Loading ...
Loading ...