INSTALLATION AND SERVICE MUST BE PERFORMED BY
AQUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
This conversion kit must be installed by a qualified service technician in accordance with the
manufacturer's instructions and all applicable codes and requirements ofthe authority having jurisdiction. Failure
to follow instructions may result in fire, explosion or production of carbon monoxide causing property damage,
personal injury or loss of life. The qualified service agency is responsible for the proper installation ofthis kit. The
installation is not proper and complete until the operation of the converted appliance is checked as specified in
the manufacturer's instructions supplied with this kit.
Before proceeding with the conversion, shut off the gas supply before disconnecting electrical
power to the range. Be sure both power supplies are off before installing the conversion kit. Failure to do so could
cause serious bodily injury.
Note: When surface burners are converted from Natural
to L.P. the BTU ratings become:
9.500 BTU* Natural Gas to 9.500 BTU* L.P. Gas
L.P. Kit Contents Kit p/n 316542400 (label color: sand)
Part Description Part Number Qty.
Surface Burner Orifice marked 0.93mm 9,500 BTU* (no color) 316527501 4
L.P. Kit Installation Instructions 316417517 1
Label- L.P. Converstion Kit 316248221 1
*Note: For operation at elevations above 2000 ft.. appliance rating
shall be reduced at the rate of 4 percent for each 1000 ft. above
sea level.
How to Convert the Range for use with LP/
Propane Gas
1. Convert the Pressure Regulator (complete this step for
ALL models):
To access the gas regulator, remove the storage drawer or Warmer
Drawer (some models). If equipped with a storage drawer, open & remove
the drawer completely. For models equipped with a Warmer Drawer,
follow the instructions below to remove the Warmer Drawer.
a. _ Electrical Shock Hazard can occur and result in
serious injury or death. Disconnect electrical power to the range
before removing the Warmer Drawer for servicing.
b. Locate glide lever on each side of drawer, pull up on the left glide lever
and push down on the right glide lever (See Fig. 1).
c. Pull the Warmer Drawer away from the range (some models) See Fig.
2).
d. Remove the regulator access cover if equipped. Do not remove the
Pressure Regulator or allow it to turn.
e. Remove the dust protector from the cap (Gas models). Use the proper
size wrench to remove the cap from the regulator(All models).
f. Follow the remaining instructions provided in Fig. 3.
NOTE: After replacing the natural gas to LP orif ces, be sure
to keep the original factory installed natural gas orifices for
future range conversion back to natural gas,
Tools Required:
3/8", 1/2" and 5/8" Open End Wrench
1/8" wide Flat Blade Screwdriver
7mm Nutdriver J
# 1 Square-Tip Driver _-_
Pull up with finger
Left Glide
Right Glide
Push down with finger
Fig. 1
p/n 316417517 (0803) English 1
Loading ...
Loading ...
Loading ...
