Loading ...
Loading ...
3
GAS CONVERSIONS
IMPORTANT: Gas conversions must be done by a qualified
installer. Before proceeding with the conversion, shut off the gas
supply to the range prior to disconnecting the electrical power.
LP Gas Conversion
1. Turn the manual shutoff valve to the closed position.
2. Unplug range or cooktop or disconnect power.
To Gain Access to Burner Valves on Freestanding
Ranges
1. Remove burner grates.
2. Remove the control knobs.
3. Open the oven door and remove the 2 screws on each side of
the range that secures the console in place.
NOTE: Leave oven door ajar, or the control console will not
rest in the side brackets properly once it is detached.
4. Pull up on the control console and let it drop forward into the
notched console brackets on each side.
WARNING
This conversion kit shall be installed by a
qualified service agency in accordance
with the manufacturer's instructions and
all applicable codes and requirements of
the authority having jurisdiction. If the
information in these instructions is not
followed exactly, a fire, explosion or
production of carbon monoxide may
result causing property damage, personal
injury or loss of life. The qualified service
agency is responsible for the proper
installation of this kit. The installation is
not proper and complete until the
operation of the converted appliance is
checked as specified in the
manufacturer's instructions supplied with
this kit.
WARNING
Explosion Hazard
Use a new CSA International approved gas supply line.
Install a shut-off valve.
Securely tighten all gas connections.
If connected to LP, have a qualified person make sure
gas pressure does not exceed 14" (36 cm) water
column.
Examples of a qualified person include:
licensed heating personnel,
authorized gas company personnel, and
authorized service personnel.
Failure to do so can result in death, explosion, or fire.
A. To range or cooktop
B. Shutoff valve (closed position)
C. Gas supply line
A. Single valve
B. Dual valve
C. Control console bracket
D. Round gaskets
A
B
C
AB
DC
Loading ...
Loading ...
Loading ...