Loading ...
Loading ...
Loading ...
10 | Wolf Customer Care 800.222.7820
ANTI-TIP BOLT ADJUSTMENT
Once the bracket is secure, adjust the anti-tip bolt so the
top of the washer is ⁄"
(22) maximum from the floor. Slide
the range into the opening and verify the anti-tip bolt is
engaged. Refer to the illustrations below.
Anti-Tip Bracket
To prevent the range from tipping forward, the anti-tip
bracket must be installed. To ensure the anti-tip bolt
engages the bracket, position the bracket 3"
(76) from the
left side of the opening. Refer to the illustration below.
INSTALL BRACKET
Drywall application: After properly positioning the anti-tip
bracket, mark the holes, then use a Phillips screwdriver
or a low rpm power drill to drive the wall anchor into the
surface of the wallboard until flush. Pre-drill the holes if
needed. For hard wallboard or double-board construction,
use a ⁄" drill bit. For solid plaster, use a ⁄" drill bit. Refer
to the illustration below. Use the #8 screws and flat wash-
ers to fasten the bracket to the wall.
Wood floor application: After properly positioning the
anti-tip bracket, drill ⁄"
(5) pilot holes through the floor.
Use the #12 screws and flat washers to secure the bracket
to the floor.
Concrete floor application: After properly positioning
the anti-tip bracket, drill ⁄"
(10) holes into the concrete a
minimum of 1⁄"
(38) deep. Use the ⁄" wedge anchors to
secure the bracket to the floor.
7
/8" (22) MAX
ANTI-TIP
BOLT
ANTI-TIP
DEVICE
ENGAGED
Anti-tip bolt adjustment
Anti-tip bolt engaged
3" (76)
ANTI-TIP
BRACKET
ANTI-TIP
BRACKET
WALL
ANCHOR
Anti-tip bracket location
Wall anchor installation
Installation
Loading ...
Loading ...
Loading ...