Loading ...
Loading ...
Loading ...
ENGLISH
6 Adjusting the angle of the speaker
There are two screws next to the ball socket joint at
the back of the speaker that tighten the joint to hold
the speaker in place. It is only necessary to loosen
one of these to free the joint. Indeed, in portrait
orientation, only one screw will be accessible
(Figure 17).
Use the supplied Torx key to loosen and tighten the
screws.
7 Rotating the badge
If using the speaker in landscape orientation, you
will need to rotate the logo badge through 90º. The
badge is spring loaded. Use the plastic lm tted to
the rear of the badge to pull it out and rotate it. After
doing so, remove the lm (Figure 18).
8 Environmental Information
This product complies with international directives,
including but not limited to:
i. the Restriction of Hazardous Substances (RoHS)
in electrical and electronic equipment,
II. the Registration, Evaluation, Authorisation and
restriction of CHemicals (REACH)
iii. the disposal of Waste Electrical and Electronic
Equipment (WEEE).
Consult your local waste disposal authority for
guidance on how properly to recycle or dispose
of this product.
6
Figure 17
Figure 18