Loading ...
Loading ...
Loading ...
80n
Check Control
Priority 2
These alerts for problems are reported
for 20 seconds when the ignition key is
in position 2. The status reports remain
after the message disappears. You can
view the message again by pressing the
CHECK button (1).
> TRUNK LID OPEN
This message is given only when ini-
tially starting off.
> DOOR OPEN
This is displayed after a minimum
vehicle speed is exceeded.
> FASTEN SEAT BELTS
*
In addition, the indicator lamp with
the safety belt symbol appears and
an acoustic signal is heard.
> WASHER FLUID LOW
The washer fluid is too low. Top up
the fluid at the earliest opportunity.
Refer to page 148.
> CHECK ENGINE OIL
Add engine oil as soon as possible.
Refer to page 149.
> OUTSIDE TEMPERATURE 247
(–5.06)
This display is only an example. The
current reading appears at an outside
temperature of 37.57 (+36) and
below. Refer also to page 76.
> TIRE PRESSURE SET
*
The RDC has imported the current in-
flation pressure in the tires as the tar-
get values which the system will
monitor.
Refer to page 98.
> CHECK TIRE PRESSURE
*
Check and correct the tire inflation
pressure to specifications at the earli-
est opportunity (next stop for fuel).
Refer to page 98.
> TIRE CHECK INACTIVE
*
A temporary interference of the RDC
or a system fault. Refer to page 99.
> BRAKE LAMP CIRCUIT
A bulb has failed or the circuit has a
malfunction. Refer to pages 170, 179
or consult a BMW center.
> CHECK LOWBEAMS
CHECK SIDE LAMPS
CHECK REAR LAMPS
CHECK FRONT FOGLAMPS
CHECK LICPLATE LAMP
CHECK TRAILER LIGHTS
CHECK HIGHBEAMS
CHECK BACKUP LAMPS
Defective bulb or circuit. Refer to
pages 167, 179 or consult a BMW
center.
> TRANS. FAILSAFE PROG
Please consult the nearest BMW cen-
ter. Refer to pages 68, 71.
> CHECK BRAKE LININGS
Have the brake pads inspected by
your BMW center. Refer to page 132.
> CHECK COOLANT LEVEL
The coolant is too low. Top up at the
next opportunity. Refer to page 151.
> ENGINE FAILSAFE PROG
Fault in the Electronic Engine Power
Control EML. When braking, higher
brake application pressure may be
necessary and brake pedal travel
may be significantly longer.
Please have the system inspected by
your authorized BMW center.
Online Edition for Part No. 01 41 0 004 597 - © 08/99 BMW AG
Loading ...
Loading ...
Loading ...