Loading ...
Loading ...
Loading ...
GROUNDING REQUIREMENTS
4
IMPORTANT: Please read carefully.
TO CONNECT ELECTRICITY
RECOMMENDED GROUNDING
METHOD
The refrigerator should always be plugged into its
own individual properly grounded electrical outlet
rated for 230 Volts, 50 Hz, AC only, and fused at
15 or 20 amperes.
This provides the best performance and also
prevents overloading house wiring circuits which
could cause a fire hazard from overheated wires.
It is recommended that a separate circuit serving
only this appliance be provided.
Use a receptacle which cannot be turned off with
a switch or pull chain. Do not use an extension
cord.
Where a standard two-prong wall outlet is
encountered, it is your personal responsibility and
obligation to have it replaced with a properly
grounded three-prong wall outlet.
Do not, under any circumstances, cut or
remove the third (ground) prong from the
power cord.
NOTE: Before performing any type of installation,
cleaning,or removing a light bulb, turn the control
(Thermostat, Refrigerator Control or Freezer
Control, depending on the model)to OFF and
then disconnect the refrigerator from the electrical
source. When you are finished,reconnect the
refrigerator to the electrical source and reset the
control (Thermostat, Refrigerator Control or
Freezer Control, depending on the model) to the
desired setting.
IMPORTANT SAFETY INSTRUCTIONS
Don’t use an extension cord
If possible, connect the refrigerator to its own
individual electrical outlet to prevent it and other
appliances or household lights from causing an
overload that could cause a power outage.
Accessibility of Supply Plug
The refrigerator-freezer should be so positioned
that the supply plug is accessible for quick
disconnection when accident happens.
Supply Cord Replacement
If the supply cord is damaged, it must be
replaced by the manufacturer or its service agent
or a similarly qualified person in order to avoid a
hazard.
FEED WATER PIPE INSTALLATION
Before installation
• Automatic ice maker can be installed only by
manufacturer.
• Automatic ice maker operation needs water
pressure of 147~834 kPa (1.5~8.5 kgf/cm
2
)
(That is, an instant paper cup (180 cc) will be
fully filled within 3 sec.).
• If water pressure does not reach the rating
147 kPa (1.5 kgf/cm
2
) or below, it is necessary
to purchase a separate pressure pump for
normal automatic icing and cool water feed.
• Keep the total length of the feed water pipe tube
within 8 m and be careful for the tube not be
bent. If the tube is 8 m or longer it may cause
trouble in water feed owing to the drain water
pressure.
• Install the feed water pipe tube at a place free
from heat.
ww
WARNING
• Connect to potable water supply only.
• Refer to instructions with water filter kit for
installation.
ww
WARNING
• The refrigerant and insulation blowing gas used
in the appliance require special disposal
procedures. When disposal, please consult with
service agent or a similarly qualified person.
ww
WARNING
Electrical Shock Hazard
FOR PERSONAL SAFETY, this appliance
must be properly grounded. Have the wall
outlet and the circuit checked by a qualified
electrician to make sure the outlet is properly
grounded.
Loading ...
Loading ...
Loading ...