Loading ...
Loading ...
Loading ...
The product you have just purchased has undergone numerous tests and inspections to
guarantee the highest quality. We hope it will give you entire satisfaction.
INSTALLATION OF THE PANEL HEATER
Please read the instructions before starting to install the heater. Disconnect the power before
carrying out any work on the heater. Keep these instructions even once you have installed your
heater.
1. Where to install your heater?
- This equipment was designed to be installed in a residence. Please ask your distributor before
using it for any other purpose.
- The panel heater should be installed according to normal trade practice and in compliance with
legislation in the relevant country (the IEE Wiring Regulations).
- The Devices used in bathrooms must be installed so that switches and other control devices
cannot be touched by a person in the bath or shower, except in the UK where IEE Regulations
701.512.2 and 701.512.3 apply. These allow the use of IP24 rated products and their integral
controls in Zone 2 and outside zones.
- Comply with the minimum clearance distances for positioning of the panel heater. ❷
- If your wall covering is laid on foam, a spacer the same thickness as the foam must be
placed under the panel heater’s support. This ensures there is free space behind the panel
heater to make sure its control settings are not adversely affected.
- Do not use the heater in the immediate surroundings of a bath, a shower or a swimming pool.
- Do not install the panel heater:
- In a draught likely to affect the control settings (under a fan, etc.).
- Under a fixed mains power socket.
- In volume 1 of bathrooms. ❶
!
It is forbidden to install vertical product in horizontal position.
Always operate the heater in an upright position with the control panel at the top.
!
2. How to install the panel heater ?
2.1. Release the appliance’s hook-on bracket ❸
We recommend that you place the radiant panel flat, face down.
Have a straight head screwdriver to hand.
2.2. Fix the hook-on bracket to wall ❹
Drilling points A
Drilling points B
Note: Approved for free standing on the feet and castor range (572000)
2.3. Connecting the panel heater
- The panel heater must be powered with 240V 50Hz
- The panel heater must be connected to the mains, either by a 2-wire cable (Brown = Phase, Blue
= Neutral) or via a power socket.
In humid areas such as bathrooms and kitchens the power socket must be installed at least 25
cm above the floor.
- The installation must be equipped with an omnipole disconnection mechanism with a break
contact distance of at least 3mm.
- The heater must be installed by a qualified electrician in accordance with the local regulations. If
the heater wire is damaged, it must be replaced by a qualified person to avoid hazard.
2.4. Lock the appliance on the hook-on bracket!❻!
!
Loading ...
Loading ...
Loading ...