Loading ...
Loading ...
Loading ...
Black plate (145,1)
北米Model "A1170BE-C" EDITED: 2014/ 3/ 17
1) Trip knob
Pressing the trip knob toggles the display
between the average vehicle speed cor-
responding to the A trip meter display and
the average vehicle speed corresponding
to the B trip meter display.
When either of the trip meter displays is
reset, the corresponding average vehicle
speed value is also reset.
NOTE
When either trip meter display is reset,
the average vehicle speed correspond-
ing to that trip meter display is not
shown until the vehicle has subse-
quently covered a distance of 1 mile
(or 1 km).
! Turn off display of driving informa-
tion display
The driving information display can be
turned off.
To turn off the display, turn the ignition
switch to the “LOCK” (off) position and
press the “+” button adjacent to the clock
display for a pproximately 5 second s.
Then, the driving information display and
the clock display will blink for 3 seconds to
notify you that the driving information
display has been turned off.
To restore the driving information display,
once again press the “+” butto n for
approximately 5 seconds.
NOTE
. The initial di spla y setting of the
driving information display has been
set to operational at the time of ship-
ment from the factory.
. The average fuel consumption and
average vehicle speed are calculated
even while the driving information dis-
play is not displayed.
. Even if you turn of f the driving
information display, the display will
automatically turn on when the battery
voltage is disconnected and then re-
connected for battery replacement or
fuse replacement.
& Clock
To adjust the time shown by the clock,
press the “+” button or “−” button. If you
press the “+” button, the indicated time will
change in one-minute increments. If you
press the “−” button, the indicated time will
change in one-minute decrements. If you
keep the button pressed, the rate at which
the indicated time changes will speed up.
The clock can be set to 12-hour or 24-hour
clock displa ys. Perform the following
procedure to switch the display format.
1. Place the ignition switch in the “LOCK”
(off) position.
2. Press and hold the “−” button that is
located near the clock display for approxi-
mately 5 seconds. The clock display will
then start to flash.
Instruments and controls/Information display
3-27
– CONTINUED –
3
Loading ...
Loading ...
Loading ...