Loading ...
Loading ...
Loading ...
10 English
REMOTE CONTROL
Your TAVH10 heater remote includes (1) coin-style CR2025 battery. Battery comes pre-installed. Remove battery pull tab before rst use. The
remote is wrapped inside a polybag and packed inside the top section of molded pulp that is placed securely around the top and bottom
of heater.
CAUTION: DO NOT
INGEST BATTERIES.
POWER ON/OFF
THERMOSTAT -/+
MODE
High Heat (1500 watts),
Low Heat (750 watts) or
Fan Only.
TIMER
1. For battery replacement, the
remote requires one coin-style
3V CR2025 battery. Always use
the correct size and grade of
battery for this product.
2. To replace battery, open
battery door on the back side
of the remote control (you will
need to loosen the small screw
on door using a #1 Phillips
screwdriver). If necessary, clean
the battery contacts and also
those of the device prior to
battery installation. Remove
any plastic protection from
the battery and place it in the
remote with the + side facing
up. Replace the battery door
and screw.
Note: Remove battery from the
remote control when not in use
for an extended period of time
and always remove dead battery
immediately and replace with
fresh. Do not store dead battery in
remote.
The remote control functions are
the same as the control panel on
the heater.
The remote requires a line-of-sight
path to allow for the signal to be
received by the heater. Position
the heater so the receiver lens
(inside the power indicator light) is
visible from the remote control.
Screwdriver required.
Loading ...
Loading ...
Loading ...