Loading ...
Loading ...
Loading ...
11
English
Your VMH600 heater remote includes (1) coin-style CR2032 battery. Battery comes pre-installed. Remove battery pull tab before fi rst use. The
remote is located inside the EPS Styrofoam surrounding the front and back of the heater. Look for the REMOTE (
È
) sticker affi xed to the remote
polybag inside the EPS Styrofoam.
REMOTE CONTROL
1. For battery replacement, the remote
requires one coin-style 3V CR2032 battery.
Always use the correct size and grade of
battery for this product.
2. To replace battery, open battery door
on the back side of the remote control
(you will need to loosen the small screw
on door using a #1 Phillips screwdriver
- screwdriver not included). If necessary,
clean the battery contacts and also those
of the device prior to battery installation.
Remove any plastic protection from the
battery and place it in the remote with the
+ side facing up. Replace the battery door
and screw.
Note: Remove battery from the remote
control when not in use for an extended
period of time and always remove dead
battery immediately and replace with
fresh. Do not store dead battery in remote.
3. Your remote control will operate the
same as the control functions located
on the heater, except when changing
modes. When changing modes, both
displays will show either LO, HI or FA
on the display as you cycle through.
Once the selection is made, it will
hold for eight seconds before room
temperature is displayed again.
The remote requires a line-of-sight path
to allow for the signal to be received
by the heater. Position the heater so
the receiver lens (inside the display
on front of heater) is visible from the
remote control.
CAUTION: DO NOT
INGEST BATTERIES.
Screwdriver required.
POWER
TIMER
THERMOSTAT -/+
MODE
High Heat (1500
watts), Low Heat
(750 watts) or Fan
Only.
Loading ...
Loading ...
Loading ...