Press the eject button to release the filter from the base grille
Pull the filter straight out.
Turn the cap counter-clockwise to remove it from the filter.
IMPORTANT: Do not discard the cap. It is part of your refrigerator. Keep the cap to use
with the replacement filter.
Align the ridge on the cap with the arrow on the new filter and turn
the cap until it snaps into place.
Note: you can run the dispenser without a filter. Your water will not be filtered. Simply insert
the cap all the way into the base grille and rotate the cap until it is firmly in place
Remove the protective covers from the O-rings. Be sure the O-rings
are still in place after the covers are removed
Push the filter into the base grille. The eject button will pop back out
when the filter is fully engaged.
Run water from the dispenser for 5 minutes (approximately 3 gallons)
to clear the system and prevent air from entering the system
Note: The initial flow rate may be slower than expected. Full flow rate should be restored
within 24-36 hours
Reset the “replace filter” light, if needed, by holding the reset button
for three seconds.
1
2
3
4
5
6
7
8
9
10
Do not use with water that is microbiologically unsafe, or of unknown quality, without adequate
disinfection. Protect from freezing.
The risk associated with small parts can cause choking if swallowed.
Keep children away from small parts during the replacement of the water filter.
FILTER REPLACEMENT SHOULD GENERALLY BE PERFORMED EVERY 6 MONTHS.
FILTER REPLACEMENT MAY NEED TO BE CONDUCTED MORE OFTEN IN AREAS
WHERE THE WATER QUALITY IS MICROBIOLOGICALLY INFERIOR.
