Loading ...
Loading ...
Loading ...
12 | Sub-Zero Customer Care 800.222.7820
INSTALLATION
Water Line
Approximately 3' (.9 m) of
1
/4" plastic tubing is connected to
the unit with a preassembled
1
/4" compression connection
under the unit. The water line tting connection kit, provided
with the unit, contains a
1
/4" compression union tting for
connection to the household water line.
Purge the water line prior to nal connection to the unit. This
will remove any debris that may be present in the tubing
from installing the new water line.
Place the sleeve and nut on the water line and fasten to the
connection at the end of the tubing. Do not over tighten.
Check all water line ttings for leaks. Verify the drain pan
can be installed and removed without interference with the
water line.
IMPORTANT NOTE: If a reverse osmosis system is used, it
is recommended the water ltration system be bypassed by
removing the lter.
IMPORTANT NOTE: Water lines cannot be exposed to
freezing temperatures.
Placement
CAUTION
Before moving the unit into position, secure door(s)
closed and protect any nished ooring.
Use an appliance dolly to move the unit near the opening.
If the unit has been on its back or side, it must stand upright
for a minimum of 24 hours before connecting power.
Plug the power cord into the grounded outlet and roll the
unit into position. Verify the anti-tip brackets are properly
engaged.
IMPORTANT NOTE: If used, the side panels must be
installed before the unit is placed in its nal position. Refer
to page 15.
Loading ...
Loading ...
Loading ...