Loading ...
Loading ...
Loading ...
8
INSTALLING THE STAINLESS STEEL HANDLES
This appliance includes two stainless steel handles
that are not required to operate the unit. To install the
handles, follow the instructions below:
1. Remove the door gasket.
2. Install the handle with the screws provided. (DO NOT
over-tighten as this will cause damage to the
stainless steel door surface.)
3. Replace the door gasket.
FULL OVERLAY PANEL INSTALLATION
INSTRUCTIONS
These models are designed for field-installed overlay
panels. The overlay panels cover the stainless steel to
give a built-in appearance. The overlay panel and
appropriate hardware are not included with the unit and
the end user needs to prepare them himself. Please
follow the instructions below for installation:
Remove any items stored inside the drawers. Press
the left slide release lever down and at the same time
lift the corresponding right slide lever up, and pull the
drawer out until it is free of tracks and the cabinet.
(Fig. 1)
Peel off the gasket and remove the handle by
removing the two screws that attach the handle to the
door.
Drill the 2 holes shown by using a 3/16” drill bit on the
bottom of drawer door front. (Fig. 2)
Cut the overlay panels with thickness 3/4” to the
following dimensions: 23.15” x 14.92”.
If reusing the handles that came with the unit, drill
two holes with diameter 3/16”in the overlay panel.
Attach the handle and overlay panel together to the
drawer face using 2 M4x55 screws and through the
upper 2 existing holes inside the door groove. Then
attach the overlay panel to the drawer face using 2
wood screws #10x1.5 (ST4x40) Type AB Phillips and
through the lower 2 existing holes inside the door
groove. (Fig. 3)
If user-supplied handles will be used, attach the
handles to the overlay panels by using the flat head
screws and drive the screws flush with the panels.
Then attach the overlay panel to the drawer face using the 4 wood screws #10x1.5 (ST4x40) and
through the 4 existing holes inside the door groove.
Peel back the gaskets, then align the left and right slide channels with the tracks in the cabinet.
Ensuring an even track engagement on both sides, gently push the drawer into the cabinet until it
stops.
Loading ...
Loading ...
Loading ...