Loading ...
Loading ...
Loading ...
REPLACING AN OLD PUMP
CONVERTIBLE WELL INSTALLATION
For parts or assistance, call ECO-FLO Customer Service at 1-877 326-3561
Disconnect power to pump before
working on pump or motor.
1. Drain and remove the old pump. Check the old pipe for
scale, lime, rust, etc., and replace it if necessary.
2. Install the pump in the system. Make sure that all pipe
joints in the suction pipe are air-tight as well as water
tight. If the suction pipe can suck air, the pump will not
be able to pull water from the well.
3. Adjust the pump mounting height so that the plumbing
connections do not put a strain on the pump body, and
ensure the pump’s height is above the water source.
Support the pipe so that the pump body does not take
the weight of piping or ttings.
1. Install the pressure gauge in the primary port as shown
in Figure 1 by removing plug and securely screwing
pressure gauge in place. Use PTFE tape on gauge
threads.
2. Install the pressure regulator control valve as shown in
Figure 2. Be sure to use the provided gasket and secure
rmly.
!
3
Convertible
Jet Pump
(Figure 1)
(Figure 2)
6
Loading ...
Loading ...
Loading ...