Loading ...
Loading ...
Loading ...
Version 3/15 - Page 20
DOWNDRAFT SYSTEM CARE
Surface of Downdraft Vent
To avoid damaging the nish, clean
downdraft vent with soap and water or
Stainless steel cleaner.
Do not use scouring powder or abrasive
solutions.
Grease Filter Care
Frequently remove and clean the lters in the
retractable section of the downdraft vent. This
will improve the operating efciency of the
downdraft vent system.
To Remove Filters:
1. Place ngertips in the embossment at the
top for the lters.
2. Press down on the lters far enough for the
tab at the top of the lters to clear.
3. Pull forward to release the lter from its
groove.
To Clean:
1. Remove the lters and clean / soak them in
hot dish detergent and water. Because the
stainless steel on the lters could be
scratched, it is not recommended that
the lters be placed in a dishwasher. The
downdraft vent will not operate when the
lters are not in place.
2. Dry the clean lters and reinstall, making
sure that they lock into place.
To Replace Filters:
1. Place lters into the retractable section of
the downdraft vent.
2. Place ngertips into the embossment at the
top of the lters and push down and back to
allow the top tabs to snap in place.
NOTE: Downdraft vent will not operate if the
lters are not in their proper position. If the
lters top tabs are not locked behind the top
ange, the vent may retract but not raise back
up.
If retractable downdraft vent does not
operate after clean lters have been
installed: Push the lter in as far as it will go.
When the lter is removed, the microswitch
behind the lter is inactivated. This feature will
not allow the vent system to operate until the
lter is properly installed.
A- Grease lter removal tab
B - Left grease lter
C - Right grease lter
Schema Elettrico Schema Electrisch
Electric Diagram Esquema Eléctrico
Schéma Electrique Esquema Eléctrico
Schema Elektrisch
Schema Elettrico Schema Electrisch
Electric Diagram Esquema Eléctrico
Schéma Electrique Esquema Eléctrico
Schema Elektrisch
4436004880 H90_040 r1 4436004880 H90_040 r1
WIRING DIAGRAM
Vent System Use
For gas cooking surfaces, the vent system may
affect ame stability and cooking performace.
To improve the burner performance, decrease
the blower speed or increase the burner
setting.
The ame sensing ignitions on some gas
cooking surfaces may be affected by the
downdraft by dispersing the ame away from
the spark igniter. This may cause the spark to
keep running while trying to reignite the burner
that is already lit. The resolve this issue,
decrease the vent speed or increase the
burner setting.
Loading ...
Loading ...
Loading ...