Loading ...
Loading ...
English
1 What’s in the box (Fig. A)
1) Headphones 2) Transmitter
3) AC/DC adaptor 4) Antenna tube
5) 2 x AAA rechargeable shortened sleeve NiMH
batteries (SBC HB550L)
2 Get started
Note
• Before using the headphones for the rst time, charge the
supplied batteries for at least 10 hours.
• Only use Philips rechargeable shortened sleeve NiMH
batteries with your headphones. Other types of
rechargeable batteries cannot be charged with this system.
• AAA alkaline batteries can be used to operate the
headphones, but cannot be charged with this system.
• If the volume of the audio source is insufcient, the
transmitter automatically turns off.
1 Install/Replace supplied batteries (Fig. B).
2 Install the antenna tube into the transmitter (Fig. C).
3 Power on the transmitter (Fig. D).
»Red LED is on when audio source is connected.
»Red LED blinks if no audio source is connected for
two minutes.
»Red LED is off if no audio source is connected for four
minutes.
4 To charge the headphones, connect the charging cable
with the headphones (Fig. E).
»Headphones: red LED is off during charge.
»Transmitter: green LED is on during charge and is off
when headphones are fully charged.
5 Power on the headphones and red LED is on (Fig. F).
6 Connect the audio device with the transmitter (Fig. G).
»Red LED is on when audio source is connected.
Tip
If there is interference, tune the transmitter and the headphones
to the same channel (Fig. H).
3 Product version table
Version / Region /10 Europe /05 UK
Input voltage / frequency 100-240V / 50/60Hz
Output voltage 8V 200mA
Carrier / Reception
frequency
Channel 1 863.5MHz
Channel 2 864.5MHz
Transmission power <8 dBm
For further product support, please visit
www.philips.com/support
Loading ...
Loading ...
Loading ...