Loading ...
Loading ...
Loading ...
wolfappliance.com
|
7
Troubleshooting
IMPORTANT NOTE: If the warming drawer does not operate
properly, follow these troubleshooting steps:
• Verify electrical power is supplied to the warming drawer.
• Verify proper electrical connections.
• If the warming drawer does not operate properly, contact
Wolf factory certied service. Do not attempt to repair
the warming drawer. Wolf is not responsible for service
required to correct a faulty installation.
Wolf, Wolf & Design, Wolf Gourmet, W & Design and the color red as applied to knobs are registered trademarks and service marks of Wolf Appliance, Inc. Sub-Zero,
Sub-Zero & Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, and Ingredients are registered trademarks and service marks
of Sub-Zero, Inc. All other trademarks or registered trademarks are property of their respective owners in the United States and other countries.
Preparation
Remove and recycle packing materials. Do not discard the
package containing two screws provided for installation.
Install an anti-tip block against the rear cabinet wall. Verify
screws are adequately secured and do not penetrate elec-
trical wiring or plumbing.
Installation
1 Turn power off to the electrical outlet.
2 Slide the left corner of the warming drawer into the
opening. If the electrical supply is located in the opening,
plug the power cord into the receptacle. If it is located in
an adjacent cabinet, guide the power cord through the
hole in the cabinet wall. Coil excess power cord behind
or beside the unit.
3 Slide the unit back into the opening until the trim
meets the cabinet front. Avoid pinching the power cord
between the unit and cabinet wall.
4 Open the warming drawer to full extension. Drill a pilot
hole in each mounting hole, located at the front, on each
side of the unit. Refer to the illustration below.
5 Mount the warming drawer using two screws provided.
6 Turn power back on to the electrical outlet.
INSTALLATION
MOUNTING
HOLE
Mounting hole.
Loading ...
Loading ...
Loading ...