Loading ...
Loading ...
Loading ...
Timer
function v
e
r
i
f
i
cation
A function which has been set is carried out after setting the time required. The “time to run” can be verified at any point by
pressing the appropriate function button.
Cancelling
timer
fu
nc
ti
ons
A program can be cancelled by selecting the manual function. When a program finishes, it is automatically cancel.
CLEANING THE APPLIANCE
Before cleaning the appliance, it should be disconnected from the power supply and turned off the main gas feeder valve.
Cleaning the work
s
u
r
f
a
c
e
Periodically clean the burner parts and trivets as lis ted below. Note that all parts must be thoroughly rinsed and dried before
being replaced.
Any liquid that overflows from pots must always be removed using a rag.
If it becomes difficult to open or close a valve, do not force it, but immediately contact the omega service department.
Cleaning the enamelled
p
ar
t
s
The trivets and burner covers are cast iron with an enamel coating. To maintain the original features of the enamelled parts
they should be cleaned frequently with soapy water. Never use abrasive powders. Do note leave acidic or alkaline substances
on the enamelled parts (vinegar, lemon juice, salt, tomato sauce, etc.) and do not wash the enamelled parts while they are still
hot.
Cleaning the STAINLESS steel
p
a
r
t
s
Clean the parts with soapy water and then dry them with a soft cloth. The shine is maintained by periodically using special
products that generally are found in the market. Never use abrasive powders.
Cleaning the burner bodies
The aluminium burner bodies sit on the burner bases. Remove from the base and wash them with soapy water. Rinse and dry,
and check that all holes and slots are fully cleaned. Replace on the burner bases, taking care that they are positioned and
orientated correctly.
Cleaning the inside of the
o
v
en
To thoroughly clean the inside of the oven, it is recommended that the door be removed first. First lock the hinge in place with the
nail supplied (01-02). With the hinges fixed, grab both sides of the door and slowly work the door off the hinges towards you. Once
fully removed, place in a safe position until it is time to fix back in place (in the opposite order). The internal rack guides can also be
temporarily removed by undoing the screws holding them in place and lifting out.
19
Loading ...
Loading ...
Loading ...