Loading ...
Loading ...
Loading ...
Reinstall The Door
1. Reattach door to dryer front panel with the 4 screws.
Partially install the screw with keyhole opening rst, and t
the keyhole opening in the hinge over the screw. Then install
the remaining 3 screws and tighten all 4 screws.
2. Check for ngerprints on the glass. Clean glass if necessary.
3. Close door and check that it latches securely.
23
A. Plug strip
B. Door strike
A.
B.
A.
B.
A. Dryer front panel
B. Door assembly
Install this
screw rst
Maintenance instructions:
n Clean lint screen after each cycle.
n Removing accumulated lint:
• From inside the dryer cabinet:
Lint should be removed every 2 years or more often,
depending on dryer usage. Cleaning should be done
by a qualied person.
• From the exhaust vent:
Lint should be removed every 2 years, or more often,
depending on dryer usage.
n Keep area around dryer clear and free from combustible
materials, gasoline, and other ammable vapors and liquids.
n Keep dryer area clear and free from items that would obstruct
the ow of combustion and ventilation air.
If dryer does not operate, check the following:
n Electrical supply is connected.
n Circuit breaker is not tripped or house fuse is not blown.
n Door is closed. Listen closely to hear the door switch activate.
n Control is set up properly and display shows cycle time.
n Cycle selection button has been pushed rmly.
n For gas dryers, check that gas supply shutoff valves are set
in open position.
If you need assistance:
Contact your authorized Maytag
®
Commercial Laundry
distributor. To locate your authorized Maytag
®
Commercial
Laundry distributor, or for web inquiries, visit
www.MaytagCommercialLaundry.com.
If you cannot locate your distributor, the Commercial Laundry
Support Center will answer any questions about operating or
maintaining your dryer not covered in the Installation Instructions.
Just dial 1-800 NO BELTS (1-800-662-3587)—the call is free.
When you call, you will need the dryer model number and serial
number. Both numbers can be found on the serial-rating plate
located in the dryer door opening.
Reverse The Strike
1. Use a small at-blade screwdriver to remove plug strip
from the dryer door opening. Slide the head of the
screwdriver under the plugs, being certain not to scratch
the dryer surface. Lift the plastic strip from the dryer slowly
to prevent distortion of the plug strip.
2. Remove the strike using a Phillips screwdriver.
3. Insert strike on the opposite side.
MAINTENANCE INSTRUCTIONS
Loading ...
Loading ...
Loading ...