Loading ...
Loading ...
Loading ...
Cadillac XT5 Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-
14590481) - 2021 - CRC - 6/2/20
230 DRIVING AND OPERATING
4. Plug the heater cord into the
connector in the front fascia.
5. Plug the cord into a grounded
110-volt AC outlet that is protected
by a ground fault detection
function.
{
Warning
Improper use of the heater cord or
an extension cord can damage the
cord and may result in overheating
and fire.
.
Plug the cord into a three-prong
electrical utility receptacle that is
protected by a ground fault
detection function. An
ungrounded outlet could cause
an electric shock.
.
Use a weatherproof, heav y-duty,
15 amp-rated extension cord if
needed. Failure to use the
recommended extension cord in
good operating condition,
or using a damaged heater or
extension cord, could make it
(Continued)
Warning (Continued)
overheat and cause a fire,
property damage, electric shock,
and injur y.
.
Do not operate the vehicle with
the heater cord permanently
attached to the vehicle. Possible
heater cord and thermostat
damage could occur.
.
While in use, do not let the
heater cord touch vehicle parts
or sharp edges.
.
Before starting the vehicle,
unplug the cord. Keep the cord
away from any moving parts.
6. Before starting the engine, be sure
to unplug and store the cord.
7. Install the engine heater connector
cover.
The length of time the heater should
remain plugged in depends on several
factors. Ask a dealer in the area where
you will be parking the vehicle for the
best advice on this.
Retained Accessory
Power (RAP)
When the ignition is turned from on
to off, the following features (if
equipped) will continue to function
for up to 10 minutes, or until the
driver door is opened. These features
will also work when the ignition is in
RUN or ACC/ACCESSORY:
.
Infotainment System
.
Power Windows (during RAP this
functionality will be lost when any
door is opened)
.
Sunroof (during RAP this
functionality will be lost when any
door is opened)
.
Auxiliary Power Outlet
.
Audio System
.
OnStar System
Shifting Into Park
To shift into P (Park):
1. Hold the brake pedal down and set
the parking brake. See Electric
Parking Brake 0 240.
Loading ...
Loading ...
Loading ...