Loading ...
Loading ...
Loading ...
9
Transfer measurement A to the cabinet back wall. Measure
from the underside of the cabinet. Mark the cutout as shown.
Use a saber saw or keyhole saw to cut a round opening
through the back of the cabinet and the exterior wall for
thevent.
Go to Step 3.
Non-Vented (recirculating) Installation Through
the Soffit/Cabinet
Measure and mark the centerline of the cabinet to the
softabove.
Measure from the bottom of the cabinet to the centerline of
the where the vent will come through the soft. Mark the
location and use a saber saw or keyhole saw to cut a 5
3
/
4
"
(14.6 cm) hole for the vent cover.
Measure and mark the centerline location for the cutout in
the cabinet top. Use a saber saw or keyhole saw to cut an
opening for the vent.
Cabinet Height Hole Shape and Size
12" (30.5 cm) A 6
1
/
4
" deep x 8" wide (15.9 cm x
20.3 cm) rectangular opening in the
cabinet top is required for damper
transition clearance.
15" (38.1 cm) cabinet
or soft installation
A 6
1
/
4
" (15.9 cm) diameter
roundopening is required.
18" (45.7 cm) or
24"(61.0 cm)
A 5
3
/
4
" (14.6 cm) diameter round
opening is required.
For non-vented (recirculating) installations only, the range
hood can be vented indoors through the top of the cabinet.
For non-vented (recirculating) installations, charcoal lters
are necessary. See the “Range Hood Care” section for
instructions on installing charcoal lters.
The Recirculation Kit Part Number W10490330 must
beused.
B
A
C
A. Measurement A
B. Centerline
C. 6
1
/
4
" (15.9 cm) round cutout
A
B
A. Vent cover
B. Centerline
D
A
B*
C
A. Cutout
B. *See chart below.
C. 7
3
/
4
" (19.7 cm) centerline to cabinet front
D. Centerline
Loading ...
Loading ...
Loading ...